[Kenwood] FILTER QUESTION AGAIN

Wed, 04 Sep 2002 18:31:29 -0600

The radio doesn't know what  8.83  filters you have installed.. You can
select filters independently in any mode (other than FM) so the filters
will work. You would still be turning on the 2.4Khz and 500Hz filters in
the menu and the radio it would show 2.4 for the 2.4 filter and 500 for the
1.8 filter, other wise there would be no problem. It's just that Kenwood
uses these predefined label to identify the filters locations.. 

the same situation as using 2.1 or  1.8 Khz and  400 or 250Hz filters, the
radio still sees them as 2.4Khz or 500Hz but they work just fine.

73. . . Ken - VE5KC

*********** REPLY SEPARATOR  ***********

On 9/4/2002 at 7:46 AM W7SAC wrote:

>TS3\450S/AT, Does any one know if I can put a 1.8 AND a 2.4 Kenwood SSB
>filters in the 8.83 filter back and select them indivually as needed. I
>know
>one slot is suppose to be for CW filter but I'd rather have the capability
>of switching between the 2 refereance filter as needed..What do you'll
>think???
>
>David S. McCallum/w7sac/4,USAF Ret./Chief Mac
>
>- - -
>
>Your moderator for this list is:
>Larry Wilson KE1HZ [email protected]
>
>_______________________________________________
>Kenwood mailing list
>[email protected]
>http://mailman.qth.net/mailman/listinfo/kenwood