[Kenwood] ts940 drive reduction???
[email protected]
[email protected]
Thu, 07 Nov 2002 20:38:26 PST
I think I am getting close to finishing one of my ts940s,
but still have a problem with a minor fluctuation in the
output power. I suspect that part of it is the protection
circuit kicking in. The ALC voltage is @2.8v and I am not
able to adjust vr3 on the control board to bring it to
the specified 3.2v. Also, if I back the carrier level
slide pot to midway, I still get about 90 watts out,
and the power level is stable. It looks like I need to back
down on the drive, but I cannot seem to see a way of
adjusting it down other than the carrier control.
What am I missing? Any suggestions would be greatly
appreciated.
cheers, Paul - VA7NT ex VE7CQK - email: [email protected]
"Those who hear not the music. . . think the dancers mad."