[Kenwood] TS-850S/AT Scan Problem

Tue, 25 Jun 2002 00:30:01 -0300

	This may be a silly suggestion, but, the scan is always up or to low
frequency?, I think it may be a short or leak in up/down mic lines,
either in the rig or in the mike (in this case, unplug the mike to
verify).

Good luck
Guillermo -LU8EYW


Chad Johnson escribi�:
> 
> During yesterday's Field Day operation my KENWOOD TS-850S/AT commenced
> scanning without being told to do so.  Once scanning started, I could not
> enter any other command, including CLEAR.  The only solution was to turn the
> transceiver off.  If I turned the  transceiver on within a minute, the
> scanning continued.  If I left it off for a couple of minutes the radio
> would work fine for a few more minutes then start scanning again.  I reset
> the microprocessor but it did no good.  I switched VFOs A and B but to no
> avail.  I was using a DELCO VOYAGER Marine/RV deep cycle battery which
> measured 12.25 volts (receive mode) at the time.  I have heard that the
> TS-850S likes to have a full 13 volts.  Words of wisdom appreciated.
> 
> Chad W4CJ
> [email protected]
> 
> - - -
> 
> Your moderator for this list is:
> Larry Wilson KE1HZ [email protected]
> 
> _______________________________________________
> Kenwood mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/kenwood