[Kenwood] TS940 ACC Ports

Wed, 5 Jun 2002 11:28:11 -0400

So the ACC port is for a TNC?  Does the TNC directions have instructions on how
to hook it up to the '940?

Mark

-----Original Message-----
From: William H Reiter [mailto:[email protected]]
Sent: Wednesday, June 05, 2002 11:13 AM
To: [email protected]
Subject: RE: [Kenwood] TS940 ACC Ports

Guys,

Well, I found the phone patch in/out ports on my 940SAT were the
quickest/easiest to use for PSK31. I still have the 13 pin ACC port for
my KAM PLus that way. I use a couple of R.S. stereo 'isolators' as a
bit of protection.

73  Bill wa2ukx

*********** REPLY SEPARATOR  ***********

On 6/5/2002 at 8:11 AM Fancher, Mark (GEAE) wrote:

>Ron,
>
>I believe there is a port for the amp hook up, a port for xverter hook
up
>and
>two additional ports labeled ACC1 and ACC2.  The operator's manual is
quite
>vague about these ACC ports.  I'm not sure what they're for, except
some
>of the
>pins are labeled for data.
>
>I'm thinking these ports could be used for convenient PSK31 hookups?
>
>Mark
>-----Original Message-----
>From: Ron Bracklow [mailto:[email protected]]
>Sent: Tuesday, June 04, 2002 6:04 PM
>To: Fancher, Mark (GEAE)
>Subject: Re: [Kenwood] TS940 ACC Ports
>
>
>Well, one of the main uses of the Accessory Port is to be able to hook
up
>an
>amplifier. this is where the switchover relay goes.
>
>Hope that helps - there is a great schematic in the Operations manual
that
>shows the hook up quite well!!
>
>Ron, N6PWW
>
>
>----- Original Message -----
>From: "Fancher, Mark (GEAE)" <[email protected]>
>To: <[email protected]>
>Sent: Tuesday, June 04, 2002 3:39 PM
>Subject: [Kenwood] TS940 ACC Ports
>
>
>> I have a TS940 that I bought used.  I'm confused about the function
of
>the
>> accessory ports on the back.  The manual isn't much help.
>>
>> Mark, AA4MF
>> - - -
>>
>> Your moderator for this list is:
>> Larry Wilson KE1HZ [email protected]
>>
>> _______________________________________________
>> Kenwood mailing list
>> [email protected]
>> http://mailman.qth.net/mailman/listinfo/kenwood
>- - -
>
>Your moderator for this list is:
>Larry Wilson KE1HZ [email protected]
>
>_______________________________________________
>Kenwood mailing list
>[email protected]
>http://mailman.qth.net/mailman/listinfo/kenwood

- - -

Your moderator for this list is:
Larry Wilson KE1HZ [email protected]

_______________________________________________
Kenwood mailing list
[email protected]
http://mailman.qth.net/mailman/listinfo/kenwood