[Kenwood] TS940 ACC Ports

Wed, 5 Jun 2002 08:11:13 -0400

Ron,

I believe there is a port for the amp hook up, a port for xverter hook up and
two additional ports labeled ACC1 and ACC2.  The operator's manual is quite
vague about these ACC ports.  I'm not sure what they're for, except some of the
pins are labeled for data.

I'm thinking these ports could be used for convenient PSK31 hookups?

Mark
-----Original Message-----
From: Ron Bracklow [mailto:[email protected]]
Sent: Tuesday, June 04, 2002 6:04 PM
To: Fancher, Mark (GEAE)
Subject: Re: [Kenwood] TS940 ACC Ports

Well, one of the main uses of the Accessory Port is to be able to hook up an
amplifier. this is where the switchover relay goes.

Hope that helps - there is a great schematic in the Operations manual that
shows the hook up quite well!!

Ron, N6PWW

----- Original Message -----
From: "Fancher, Mark (GEAE)" <[email protected]>
To: <[email protected]>
Sent: Tuesday, June 04, 2002 3:39 PM
Subject: [Kenwood] TS940 ACC Ports

> I have a TS940 that I bought used.  I'm confused about the function of the
> accessory ports on the back.  The manual isn't much help.
>
> Mark, AA4MF
> - - -
>
> Your moderator for this list is:
> Larry Wilson KE1HZ [email protected]
>
> _______________________________________________
> Kenwood mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/kenwood