[Kenwood] new reflector software glitch?

Fri, 11 Jan 2002 05:51:32 -0600

I agree with Mike.  I don't want to have to double check my email to make sure
where it's going.  99% of the lists reply to sender NOT the list.  Reply to ALL
works great and if a person has seen an email of interest he can always go back
and ask the originator for the answer.

I humbly request the Kenwood list guru reset this option to only reply to
sender.

Best 73 all, gary

===============
Gary H. Harmon, Jr.
K5JWK
6302 Robin Forest
San Antonio, TX 78239
(210) 657-1549
==================

-----Original Message-----
From: [email protected]
[mailto:[email protected]]On Behalf Of Mike D.
Sent: Friday, January 11, 2002 5:15 AM
To: [email protected]
Subject: RE: [Kenwood] new reflector software glitch?

> Sorry I do not agree as very often the follow up reply to a help request
> gives information that is worth while to keep even though at the time one
> does not have the fault. Personnally I store all information that
> applies to
> Kenwood TS870 rigs

If the default is "reply to sender" and the poster wants everyone to read
his reply, HE can use "reply to all" on his e-mail client and it will go to
the list as well as the sender. When 90 plus percent of the reflectors have
their configuration as "reply to sender" it is reasonable to expect some
consistency with this group as well.

Also, it's a good idea to only quote the relevant parts in a reply message.
Not the entire thread.

73 de Mike, N9BOR
FISTS MAC SMC ZUT
http://www.qsl.net/n9bor
MAC http://www.qsl.net/mac

di dah dit - The only Roger Beep you'll ever need.
My designated driver is a 12BY7A.

- - -

Your moderator for this list is:
Larry Wilson KE1HZ [email protected]

_______________________________________________
Kenwood mailing list
[email protected]
http://mailman.qth.net/mailman/listinfo/kenwood