[Kenwood] TS-930s TX audio

Thu, 08 Aug 2002 20:48:56 -0300

	If with low settings of mic gain audio sounds clipped, may be a bias
problem. Check bias voltages of pre-driver, driver pair and final pair
transistors. You should measure 0.6V...0.75V; put rig on tx, ssb, zero
mic gain and test from emitter to base.

Good luck
Guillermo - LU8EYW.

John Peregord escribi�:
> 
> My TS-930S has a problem on the TX audio.  RX and CW transmit is fine.  I'm
> told the audio sounds clipped and I must run with the mic gain almost all
> the way up.  I can turn it back and run with the processor on and it sounds
> better but still not quite right.  Maybe somebody has run into this before?
> Any help will be appreciated.
> 
> John/KB8UMD
> 
> - - -
> 
> Your moderator for this list is:
> Larry Wilson KE1HZ [email protected]
> 
> _______________________________________________
> Kenwood mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/kenwood