[Kenwood] 950SDX Sub Receiver Question

[Dave Henderson]

Ron et all

I think this is what you are looking for

To enable dual band receive on TS-950SDX.
Power off
Hold down buttons Sub, M/S, RX/sub
Now turn power on.

To return things to normal repeat the process and the sub receiver toggles 
back to following the active VFO.

The downside is that the bandpass filters aren't "dual" so sensitivity is 
significantly reduced on the sub receiver when listening out of band, 
because the band pass filter is slaved to the main or active VFO

Dave
NR1DX


At 11:16 AM 4/28/02 -0400, Ron Goldstein wrote:
>Hi All,
>
>         I was wondering if it is possible to have the main receiver on 
> one band, and the sub receiver on another band ???  Somewhere in the back 
> of my mind, I think I remember someone coming up with a way of doing 
> this. I tried this morning, but could not do it. I know that you can have 
> VFO A on 1 band and VFO B on another, but you cannot listen on 2 
> different bands this way--the sub receiver switches to the same band that 
> either VFO is listening to.. Any ideas ???
>
>
>                                 RON....KA2IIA