[Kenwood] R-2000 Antenna Fuse Question

Mon, 15 Apr 2002 14:35:53 -0500

Take the bottom off and it's on the right. Looks just like a regular fuse in
a holder.

Clif Holland, KA5IPF
AVVid
Authorized Kenwood and Icom Amateur Service
www.avvid.com
1-800-214-5779

----- Original Message -----
From: "Frank Ammerman" <[email protected]>
To: <[email protected]>
Sent: Monday, April 15, 2002 11:56 AM
Subject: [Kenwood] R-2000 Antenna Fuse Question

> Repost:
>
> My R-2000 has no S-meter movement, and nothing but noise on all bands
> except I can hear a few strong SW broadcast signals around 5 and 9 MHz. I
> saw in the manual that this could be an open antenna fuse -- I suspect
> maybe my transmit on my TS-830s with the R-2000 long wire attached, or my
> failure to disconnect my R-2000 antenna during recent storms may have
> opened the 100mA antenna fuse.
>
>  So before I delve into the innards, I was curious...How difficult is it
to
> get to the fuse? After I pull the top cover will I have to remove a board
> or assembly to access the fuse? Is it soldered in? Are there any "gotchas"
> I should be looking out for? Thanks!
>
>  KB3DLH
>
>
> - - -
>
> Your moderator for this list is:
> Larry Wilson KE1HZ [email protected]
>
> _______________________________________________
> Kenwood mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/kenwood
>
>