[Kantronics] KAM & KPC-4 Question

Mon, 23 Jun 2003 10:03:58 -0700

You could have an issue of too low of voltage to key the transmitter etc.
Calculate the line loss for the gauge of wire you wan to run.  Shield the
audio line well too.  Otherwise, you may see too much noise in the signal
and a high error rate.

Grant
[email protected]
KB7WSD

> -----Original Message-----
> From: [email protected]
> [mailto:[email protected]]On Behalf Of Jay Coote
> Sent: Friday, July 10, 2893 3:44 PM
> To: [email protected]
> Subject: [Kantronics] KAM & KPC-4 Question
>
>
> I might need to mount dedicated HF or VHF radios 40 feet (in
> wire) away from the workstation,  are there any caveats about
> "long" cable runs between the
> TNC and radio?
> Thanks,
> Jay Coote
> Los Angeles
> Specialist in Technical Surveillance Countermeasures
> Lic:  PI17926
> [email protected]
>
> _______________________________________________
> Kantronics mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/kantronics
>