[K3CAL] Power Supply Problem

[Karl Long]

I have two radios, both ICOMs. One is a 706MKIIG, the other is an IC-735.
I have two power supplies, an Astron 20A (don't know what model).  The other is a Pyramid Phase III, model PS-35. Actually, I now have two of them.

I am using a Gap Titan antenna.

When I connect either radio to the Astron power supply, they both work fine on all modes, all bands at full power (150 - 200 W).

With either radio connected to the Pyramid power supply, I can transmit full power, all modes on 10m.  But on 20m, I can transmit low poser (10 W) on the 735, but if I go up to about 20 or 30W or more, as soon as I press the PTT on the mike (AM, FM, or key CW) or start to talk on SSB, the power supply trips off line.  If I turn the power supply off and then back on, it works again.

This behavior has been consistent since I setup the antenna.  I analyzed the antenna and there is no problem with the antenna on any bands that I used.  As far as I can tell, this has happened every time I used the Pyramid power supply.

My first Pyramid PS-35 finally died. When I turn it on, it immediately blows the fuse.  I just borrowed another PS-35 and it behaves the way the first one did, as described above.

Has anyone heard of a problem like this, or have any suggestions?

Karl
KG1L

 		 	   		  
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mailman.qth.net/pipermail/k3cal/attachments/20150610/970a5edf/attachment.html>