[JRC] Nrd545 query

[Charles]

Hi all,

I am continually writing new functions for my NRD545 via a windows 
program I wrote.
I have often wondered about some commands in the manual of the 545 
however?  I
was wondering if anyone knew what they actually are for?   So, on page 29
of the operating manual of the NRD545, there's a list of comments under the
title:  "MM" Set numerical keypad, buttons

Command                        Description

"MM00"CR                           0
"MM01"CR                            1  

etc

If I send any of these commands to the receiver, the command does what
the description says.  However, in the title above it says that these
commands set the keypad, buttons (?)  I would assume they are referring
to the keypad on the NRD545, but aren't all the buttons already set?

Anyone have any ideas?

Thanks

Chuck Bolland
ka4prf@us-it.net