[JRC] JST-245 Audio line out

[Brooke Clarke]

Hi Fabio:

Although I don't have any information specific to the 245, It's my understanding
the "line out" means that the signal is intended to drive a 600 Ohm load and
it's amplitude is a constant value, maybe 1 mW.  This is way more than comes out
of a microphone so don't feed it directly into a  MIC input.

The AGC will be however you set it.

Brooke Clarke, N6GCE
http://www.prc68.com

Fabio wrote:

> Hi guys,
>    I am thinking about recording some audio (for contests and so) from my
> JST-245.
> I am going to use the LINE OUT pin on the accessory connector on the back
> of the 245, but I am thinking if the AGC is active on this output...
> Anyone knows something more?
> Thanks a lot
> Ciao
>     Fabio
>     IZ4AFW
>
>   Effugere nemo id potest, quod futurum est. (Publilio Siro)
>
> --
> EMail                   iz4afw@libero.it
>                          fabio.mantovani@inwind.it
>                          iz4afw@amsat.org
>                          iz4afw@qsl.net
>          - PGP key available on request -
> Home Page               http://surf.to/manto   *OR*
>                          http://www.qsl.net/iz4afw
>
> _______________________________________________
> JRC mailing list
> JRC@mailman.qth.net
> http://mailman.qth.net/mailman/listinfo/jrc