[Johnson] Re: DO NOT Solid State the Power Supply in yourRanger!!

[Sherrill Watkins]

Larry: My experience has shown that my Drake TR-4C will begin to damage some
of its tubes in about 18 months even with a cooling fan mounted over the top
of the cabinet above the final amplifier cage. The fan is blowing up. Do you
have specific information about how to correct this? If so, please share it
with me. Thank's  - Sherrill W. k4own. 

-----Original Message-----
From: Larry Knapp [mailto:kc8jx at yahoo.com] 
Sent: Tuesday, October 19, 2004 1:31 PM
To: Johnson at Mailman. Qth. Net
Subject: Re: [Johnson] Re: DO NOT Solid State the Power Supply in
yourRanger!! 


I have to agree with Glen here.  There are most likely thousands of solid
state power supplies in use for Heath, Drake and Collins....most likely
others.  The Heath and Drake transmitters do not come with fans.  In all the
Drake forums a constant is to get the Drake transceivers and transmitters
fans to cool them down.  I would believe it's the heat coming from the 6JB6's
that perhaps may cause failure over time in these units...be they tubes or
components.  My R4B can run hours with what I consider normal heat from the
components used. 
However, when I use my TR4CW or my T4XB, the heat from these units is huge. 
Fans are on both.  I hope this prolongs their life.

73, Larry KC8JX

--- Glen Zook <gzook at yahoo.com> wrote:

As for the problems with your TR-4C tubes, frankly, I have never run into
such in either my equipment or the equipment that I service for others.  I
have worked on various Drake 4-Line equipment that belong to locals that
still have a number of the original tubes in them and have never had to
replace a single tube in any of that equipment.  Thus I cannot recommend
anything that may be wrong in your particular power supply.  But, I have not
seen the problem in any solid-state supplies in either my own equipment or in
the numerous units that have been sent in for alignment, etc., over the
years.
 
Glen, K9STH  
 
> --- Sherrill Watkins
> <Sherrill.Watkins at dgs.virginia.gov> wrote:
 
My Drake TR-4C will damage some of its tubes in about 18 months; based about
two or three on-off cycles per day. I have quit using it because of its
tendency to damage tubes so quickly. I plan to install a time-delay relay in
the center tap groud of the power supply to allow the filiments to warm
properly before the B+ is applied before I use it again. My high AC line
voltage (125vac!) doesent help matters.




		
_______________________________
Do you Yahoo!?
Declare Yourself - Register online to vote today! http://vote.yahoo.com
Johnson mailing list
Home: http://mailman.qth.net/mailman/listinfo/johnson
Help: http://mailman.qth.net/mmfaq.html
Post: mailto:Johnson at mailman.qth.net