[Johnson] A question from A New BA operator.

Wed, 20 Mar 2002 15:23:56 -0600

While restoring my valiant, I found(as the manual suggests ) that less
loaded causes high modulator current-so I tune it up to full power.   cliff
k9jts
----- Original Message -----
From: "Mullin, Edward J." <[email protected]>
To: <[email protected]>
Sent: Wednesday, March 20, 2002 1:40 PM
Subject: [Johnson] A question from A New BA operator.


> Hello All,
>
> I've been lurking on this mail list for a while, as I've been
> working on my Valiant.  So far I have gotten it working again, (recapping
> and replacing a couple of tubes was all it needed:)   Now I want to use it
> on the air.  (I've been testing into a dummy load during restoration). I'm
> new to BA's (and Ham operations) in general, and  I've been reading the
> manuals alot.  What I want to know is: What is the correct method for
> transmitting at less than full power. The manual is good at describing the
> tuning process, but it doesn't really cover this information.(at least I
> didn't figure out where it was.)
>
>
> 73 de KB1HYS
>
>
> > Edward Mullin
> >
> >
> _______________________________________________
> Johnson mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/johnson