[InHam] Moving and Clearing Out

[k9ofg at aol.com]

I'll be moving out of state soon and need to sell most of the ham gear.  Located in Indianapolis.  Best offer will get it.

Rohn 25 tower...four full sections and a top section.  WITH ROHN TOWER ERECTION MANUAL  On the ground.  No rust.  Has been painted.  Legs were never torqued, so easy erection can be anticipated.
Ham II Rotator.  NEW IN BOX!  Staples never removed!  Have new grease to re-lube the gears.  (Hy-Gain's recommendation)  $150
TET 33 beam.  10-15-20 M three element beam.  Needs new center insulators.  Balun could stand to be replaced, too.  Has been in garage for at least 10 years.  Have some literature on the TET
Globe Champion 350.  Dirty  With manual
Drake 2B, Speaker/Q multiplier, Calibrator, LF converter   With manual (water damage) Was bought new and never used hard.  All paint is still on front panel.  Dirty
Kenwood TS 940AT.  Shipping accident probably makes this mostly a parts machine, though it does work.  More than one board was repaired.  Part of (copied)manual
ARRL Handbooks.  Quite a few dating 1954-2001, though not complete set. (Do have a 1942 edition, one of the war-time editions)
E&E Amateur Handbook (Hard binding)  10-15 issues, though not complete set.  I set out to build a complete set, but didn't make it.  
ICOM 22S, 22U, neither operable
Heath 2 m HT.  Audio weak.  
Lot of books from the 60s and 70s, mainly.  Most from CQ and ARRL  (No magazines--they are gone)

Richard Owens, K9OFG
K9ofg at aol.com