[ICOM] APF filter question

[John Geiger]

Hi Dave,

Thanks for the information.  It sounds like the 7000 and 7100 might have
tools to overcome the lack on an APF on CW.

73 John AF5CC

On Wed, Feb 22, 2017 at 1:59 PM, Dave 'Doc' Corio <dcorio at zitomedia.net>
wrote:

>     John, I recently switched from the IC-746 to the IC-7200. The APF on
> the 746 was excellent, but I believe the DSP on the 7200 is a bit better.
>
>     On the 746, I always had to "fiddle" with the APF, especially if the
> other station was a bit off my zero beat. In narrow (80 Hz) mode it did
> eliminate a lot of other signals. However, being able to adjust the DSP
> filter from 3600 Hz down to 50 Hz, is much easier to use in that same
> situation.
>
>     For example, I always had the APF on the 746 tuned to my 600 Hz
> sidetone. If conditions warranted I could turn that on in one of the three
> bandwidths easily, But if the other station was at 750 Hz, tuning the APF
> in one of the narrow modes got tricky.
>
>     On the 7200, I can turn the DSP in very small steps, instead of only
> three choices, until only the noise is eliminated. I haven't yet used it in
> the narrowest (50 Hz) width, but have stopped it down to 150 Hz with good
> results. It doesn't have the "ringing" quality that the 746 had using the
> APF.
>
>     The DSP on the 7200 also works MUCH better on the digital modes than
> the optional filters (500 Hz and 250 Hz) I had in the 746.
>
>     I operate very little SSB, so my opinion only apples to CW, and as
> most "opinions", it's impossible to quantify! This is just my preference.
> YMMV!
>
> 73
>
> Dave KB3MOW
>
> On 2/22/2017 2:40 PM, John Geiger wrote:
>
>> One of the more useful CW tools on some Icom rigs is the APF filter where
>> a
>> thin slice of receive (where the CW signal is) can be increased to boost
>> it
>> out of the noise.  This feature is found on the 746 and 756 original, and
>> I
>> think it reappeared on the 7600.  The HF/VHF/UHF radios like the 7000 and
>> 7100 do not have it.  Since they have IF DSP does narrowing the CW filter
>> down to 150hz or so pretty much replicate this feature, or are you still
>> missing out because you don't get the "boost" that the APF gives?
>>
>> 73 John AF5CC
>> ----
>> Your Moderator: Dick Flanagan K7VC: icom-owner at mailman.qth.net
>> Icom Users Net: Sundays, 1700Z, 14.316 MHz
>> Icom FAQ: http://www.qsl.net/icom/
>> To support QSL/QTH.net: http://www.qsl.net/donate.html
>>
>>
>
>
> ---
> This email has been checked for viruses by Avast antivirus software.
> https://www.avast.com/antivirus
> ----
> Your Moderator: Dick Flanagan K7VC: icom-owner at mailman.qth.net
> Icom Users Net: Sundays, 1700Z, 14.316 MHz
> Icom FAQ: http://www.qsl.net/icom/
> To support QSL/QTH.net: http://www.qsl.net/donate.html
>