[ICOM] Icom Xcvr, Filter, Brackets, and more FS

[Ken, W8EK]

HF + VHF + UHF Transceiver, Crystal Filter,
Mounting Brackets, Cables, Microphones, Power
Cord, Linear Amp Cable, and more For Sale:
.
.

Icom IC-706 Mk II G, 160 m to 440 MHz transceiver:

The 706 Series is one of the most popular transceivers in
amateur radio history. The IC-706 Mark II G adds many new
features and capabilities not found in the previous versions.
The "G" is an all-mode transceiver providing 100 watts on
HF/6 m, 50 watts on 2 m, and 20 watts on 440 MHz. It receives
from 30 KHz to 199 MHz and 400 to 470 MHz. It has a removable
front panel that allows control of all features. The UT-106 DSP
module is standard. One or two optional filters may be added.

Features:
.03-199, 400-470 MHz Receive
Alpha memories
Preamp/ATT
VFO A/B
IF Shift
Scanning
S/RF Meter
100 Watts HF+6M, 50 Watts 2M, 20 Watts 440
100 Memories
All band Multimode
Removable head
Mini Spectrum Scope
Electronic Keyer

This particular unit includes hand microphone,
power cord, and manual in its original box.
All looks and works great.

Only $625.
.
.

Icom Crystal Filter:

This filter is for use in Icom rigs with the
9 MHz IF, and includes the Icom 706 series radios,
IC-746, IC-756, IC-775/DSP transceivers and the IC-R75
receiver, among others. It is a plug in filter, so
it can be easily installed.

FL-100 500 Hz CW Filter
Although usually used for CW, it is also useful for
digital modes.
Still in its original box, apparently unused. $75
.
.

Mounting Brackets:

MB-51
This is an odd mounting bracket that is not often found
in ham circles.  It can attach to a dash and swivel to
most any direction.  It has a screw to take "head mounts"
such as the MB-63 for the IC-706.  Basically it is an
additional way to mount a remote head.  It is chrome
plated, and really looks great.  $40

MB-62
Standard mobile mounting bracket for the IC-706, AT-180,
IC-7000, IC-7100, and others.
Still in its original box, complete with all hardware. $25

MB-63
Bracket to mount the control head of the IC-706 and
maybe others.
Still in its original box, complete with all hardware. $25
As above, but not in original box.  $20

.
.
Heil AD-1 for Icom
This adapter has a round 8 pin connector wired for Icom
on the radio end. The other end has a 1/4 inch jack
for a PTT switch, and an 1/8 jack for microphone. $15
.
.

Microphones
.
Icom HM-103
Includes up/down switches on it. It has a modular
8 pin connector on it, and is often used on the
Icom 706 series of transceivers, among others.
This one works 100% and looks extremely nice. $40
.
Icom HM-23
16 digit DTMF mic with Up/Down switches.
Round 8 pin connector fits most Icom rigs using a
round 8 pin connector.
Works and looks like new. $40
.
Icom HM-36 Electret Hand Mic
Similar to HM-12, but electret mic element.
Used on most of the newer Icom rigs with round
8 pin plugs. Requires polarizing voltage.
Works 100% and looks like new. $30
.
.
Icom HM-46 L Speaker Mic
Nice compact speaker mic that sounds great.
Looks like new. $20
.
.

DC Power Cable

This is the heavy duty power cable as used on most of
the Icom HF rigs, plus also many Kenwood, Alinco, and others.
It has the 6 pin molex connector, with four pins used - two
for plus and two for ground.
It looks good, and of course works fine. $22
.
.
Linear Amp Switching Cable:

This cable goes from an Icom transceiver to a linear
amplifier to switch the amp from transmit to receive.

One end has a DIN connector, as is used with most Icom
rigs. The other end has an RCA phono plug, as used by most
linear amplifiers.

Before using this cable, please check the switching
capabilities of your transceiver, and the requirements
of your amplifier.

Cable with ALC and relay switching, designed for use on
an Icom 706. It can also be used on many other Icoms. $20
.
.
Cable for Icom Transceiver to Digital Controller:

The package says "The Country Ham RTC2-Ic", TNC-Radio
Cable w/ DIN and Mike Plug. For use with MFJ, AEA, and
PacComm TNCs using a 5 pin DIN plug. The opposite
end has a round Icom 8 pin connector as used on most
Icom rigs. Pin outs are listed on the label.

There is also an attached cable with 1/8 inch plug to
go to the speaker jack.

This cable is apparently new, still in its original bag.

$15
.
.

Icom Battery Chargers:

Icom BC-72 desk charger,
For IC-2 S RA series, plus others. $30

Icom BM-103 Desk Charger
Excellent condition. $12

Icom BM-104 U Wall Charger
Provides 12 V DC at 1 amp to charge many different
battery packs. $12

Icom BC-127 A
This charger charges the NiCads or NiMH for the IC-Q7 A
Dual band HT, and Icom R-2 receiver, and probably others.
This one appears to be new, unused, still in its bag.
Icom lists them at $21. Buy this one for $10.
.
.

Batteries and Desk Charger for Icom:

Batteries and desk charger for Icom IC-24, IC-2 SAT, IC-W2A, IC-2 SRA, 
and others.

W & W 7.2 Volt 2500 NiMH battery for IC-2 SRA, new, not used, $40

Batteries America, BP-83 H, 7.2 V, 1100 mahr NiMH battery for
IC-2 SRA, new, not used, $30

Additional W & W 12 Volt 600 mahr NiCad, dead, good for rebuilding, $5

Icom BC-72 desk charger,
Charges BP-81, BP-82, BP-83, BP-84, BP-85 and maybe more. $30

Buy all of the above for $75.

.
.

I also have many other accessories of many different brands
available.
Just too many to list here. Please e-mail your requests.


Prices do not include shipping from Florida.

Thanks.

73,

Ken, W8EK

Ken Simpson
E-mail to W8EK at FLHam.net or W8EK at arrl.net
Voice Phone (352) 732-8400






.