[ICOM] Replace lamp in S meter 756 Pro

[William Chapman]

Thanks much Larry!!

Another kind Ham posted the procedure which I have pasted here!

You will need to take off the front panel from the main chassis then remove the plastic front panel
from the sheet metal that it is mounted too. Then you will need to remove the PCB that the meter
is attached too.  The lamps are 4  LED's 2 each in series with each other along with a series dropping
resistor. I have found in the past you may have 2 of those LED's that are open and happen to be one
in each series string.
Sounds complicated? It is and you need to be careful removing and plugging in those ribbon cables.
Best help would be to get a service manual first though.
Bruce W7BCW 

Bill

W5YJB

++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++




"A general dissolution of principles and manners will more surely overthrow the liberties of America than the whole force of the common enemy."

—Samuel Adams (1779)
-----Original Message----- 
From: Larry L. Hinton 
Sent: Tuesday, November 29, 2016 2:39 PM 
To: ICOM Reflector 
Subject: Re: [ICOM] Replace lamp in S meter 756 Pro 

Bill,
I know it has been discussed on this forum many times. I am not on my computer or I would provide a link for the reflector search page. Someone else should be able to provide the link though.
LarryK7YBZ

      From: William Chapman <w5yjb at sbcglobal.net>
To: icom at mailman.qth.net 
Sent: Tuesday, November 29, 2016 11:22 AM
Subject: [ICOM] Replace lamp in S meter 756 Pro
   
My S-Meter lamp is out in my IC 756 Pro. Removing the top cover shows NO access to the 
meter so the lamp can be replaced.

Anyone have a suggestion?

Perhaps a site where I can go to obtain instructions? I’ve tried the usual with no success.

Bill

W5YJB
++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++




"A general dissolution of principles and manners will more surely overthrow the liberties of America than the whole force of the common enemy."

—Samuel Adams (1779)

---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
----
Your Moderator: Dick Flanagan K7VC: icom-owner at mailman.qth.net
Icom Users Net: Sundays, 1700Z, 14.316 MHz
Icom FAQ: http://www.qsl.net/icom/
To support QSL/QTH.net: http://www.qsl.net/donate.html

   
----
Your Moderator: Dick Flanagan K7VC: icom-owner at mailman.qth.net
Icom Users Net: Sundays, 1700Z, 14.316 MHz
Icom FAQ: http://www.qsl.net/icom/
To support QSL/QTH.net: http://www.qsl.net/donate.html