[ICOM] Icom HF Xcvr, Desk Mics, PSs FS

[Ken, W8EK]

Icom HF Transceiver, Desk Microphones, Power Supplies For Sale:


Icom IC-751 A, HF Transceiver:

The IC-751A is an advanced transceiver covering 160-10 meters.
It has a high performance general coverage receiver. Output is 10
to 100 watts SSB/CW/RTTY/FM modes (40 W on AM). The 751A
has sophisticated capabilities such as dual VFOs, Notch, Passband
Tuning, RIT/XIT, and 32 memories. Serious CW operators will
appreciate the built-in electronic keyer, standard FL-32A 500
Hz CW filter, sidetone, plus full and semi break-in capability.
The rear panel has an SO-239 antenna jack plus a receive only
RCA phono jack. It requires 13.8 VDC at 20 amps.
12 x 4.5 x 14 inches.

Features:
All Mode
Analog S/RF Meter
160-10 Meters including WARC Bands
All Mode Squelch
100 Hz Display
CW break-in
PBT
32 Memories
RIT/XIT
Noise Blanker
Notch

This is a terrific unit. Everything works 100%, and it
looks fine.
Hand mic, power cord, and paper work included for $500.


Icom SM-8 Deluxe Desk Microphone:

The Icom SM-8 desk mic has an electret condenser type mic
element and gives clear tone over a wide variety of voice
levels. The gooseneck may be adjusted to any angle. It
features UP-DOWN tuning and has two line inputs (A/B) for
operation from two transceivers. Icom even includes the
second mic cable that you can connect if needed.

It has a gain adjustment and a Low Cut switch, and is powered
from the Icom transceiver. The mic cables terminate in a
standard Icom 8 pin mic plug. This mic works with the 718,
746, 746 Pro, 756, 756 Pro, 756 Pro II, 756 Pro III, 775, 781,
820, 821, 910H and 920.
The SM-8 can also be used with the 706 series with the addition
of the optional OPC-589 mic adapter cable.

Although I can not confirm for sure, since this mic came from
an SK, it appears to be new, unused.

Only $125.


Icom SM-6 Desk Microphone:

The Icom SM-6 is a unidirectional, electret microphone
designed for base station operation with many Icom
transceivers.  The SM-6 features a switch for PTT
(push to talk) and also a lock feature.

There is a free-bending neck for convenient adjustment.
On the bottom of the mic base there is an adjustment for
Low to High. This mic is powered from the Icom transceiver.
The mic cable terminates to a standard round Icom 8 pin
mic plug. This mic works with the 28, 78, 271, 275, 471,
475, 718, 745, 746, 746 Pro, 756, 756 Pro, 756 ProII, 775,
781, 900, 901, 970, 1275 and many others

This one works fine and looks extremely nice.
With paper work for $65.


Astron RS-20 A, 20 amp Power Supply:

The Astron RS-20 A is a very common power supply around
most ham shacks. It provides 13 V DC for many ham rigs.

Features:
Solid State Electronically Regulated
Fold-Back Current Limiting Protects Power Supply from
...excessive current & continuous shorted output
Crowbar Over Voltage Protection
Excellent Regulation & Low Ripple at low line input voltage.
Heavy Duty Heat Sink
Chassis Mount Fuse
Three Conductor Power Cord

Specifications:
Input Voltage 105-125Vac
Output Voltage 13.8Vdc (internally Adjustable 11-15V)
Ripple Less than 5mV peak-peak (full load & low line)
Continuous Duty 16 Amps; ICS 20 Amps
Size 5" x 9" x 10-1/2"

This particular supply works great. It only varies 0.01 Volts
with a load! Cosmetically it looks great.

With paper work for only $65.


Kenwood PS-30 Power Supply:

The Kenwood PS-30 power supply provides 13.8 VDC at
20 Amps intermittent or 15 Amps continuous. It features
large heat sinks and automatic overload reset. Ripple
voltage is less than 20 mv at 13.8 V DC 20 Amps.
Input is 120 or 220 V AC.
7.2 x 5.3 x 11.5 inches

The PS-30 has two output connections. It has a 6 pin molex
connector as used on many, many Kenwood rigs, and also
on many Icom, Yaesu and Alinco rigs. In addition there
are screw terminals for lower current output, normally
used for a 2 meter or dual band rig.

This one works fine and looks great.

Paper work is included for $100.


I also have many other accessories available such as many
different types of microphones, HTs, VHF and UHF rigs, HF
and VHF/UHF antennas, connectors, miscellaneous accessories,
etc.
Just too many to list here. Please e-mail your requests.


Prices do not include shipping from Florida.

Thanks.

73,

Ken, W8EK

Ken Simpson
E-mail to W8EK at FLHam.net or W8EK at arrl.net
Voice Phone (352) 732-8400