[ICOM] FW: Info on Icom PS-55 Needed

[Jim Hargrave]

Sounds like someone wired the toggle switch in series with the 735
power switch.
If you leave the toggle switch ON, does the 735 switch power the
supply ON/OFF?
Another thought. The 735 power switch is small and should not be
wired directly to the AC input.
Perhaps someone has wired a relay circuit to turn on the primary.

73, Jim - w5ifp at gvtc.com

>> -----Original Message-----
>> From: Icom [mailto:icom-bounces at mailman.qth.net] On Behalf Of
>> D C _Mac_ Macdonald
>> Sent: Thursday, June 18, 2015 1:20 PM
>> To: Icom Forum
>> Subject: [ICOM] FW: Info on Icom PS-55 Needed
>> 
>> Some time ago, I bought a PS-55 on eBay.  Today, I finally opened
it
>> up and found that some previous owner had put a toggle switch on
>> the side of the chassis/case.
>> 
>> I suppose that this toggle switch ONLY energizes to power supply,
>> but it does not actually power up the IC-735 for which I bought
the
>> PS-55.  Both the added toggle on the PS-55 AND the power switch
>> on the 735 must be used to power up the rig.
>> 
>> Does anybody have a link to the schematic for this power supply
or
>> even an original manual (or copy)?
>> 
>> * * * * * * * * * * *
>> * 73 - Mac, K2GKK/5 *
>> * (Since 30 Nov 53) *
>> * k2gkk hotmail com *
>> * Oklahoma City, OK *
>> * USAF & FAA (Ret.) *
>> * * * * * * * * * * *
>> 
>> 
>> 
>> 
>> 
>> ----
>> Your Moderator: Dick Flanagan K7VC: icom-
>> owner at mailman.qth.net Icom Users Net: Sundays, 1700Z, 14.316
>> MHz Icom FAQ: http://www.qsl.net/icom/ To support
>> QSL/QTH.net: http://www.qsl.net/donate.html