[ICOM] 765 freq problem

[rrocket88 at netzero.net]

Rich, Thanks for the original article and the update info..  I have had that link bookmarked way long years ago,

73 K4iMZ 

---------- Original Message ----------
From: Rich Dailey <redailey1 at gmail.com>
To: ICOM Reflector <icom at mailman.qth.net>
Subject: Re: [ICOM] 765 freq problem
Date: Thu, 26 Feb 2015 10:41:36 -0500

I'm the author of that page. I need to mention that I'm not sure of the
availablility of the replacement trimmers that are mentioned in the
article. If someone has a good link to a supplier of substitutes, I'll
update the page to add those links. Been a lot of years.

Also, I'll throw in that I recall having one on the bench that had a
sililar drift situation. I replaced the trimmers, AND
10uf bypass caps coming off a 5 volt regulator. They were pulling hard on
that supply voltage. Seems
it was on the board under the power supply, on a long, shared heat sink
with other regulators. Like I said,
it's been many years, my brain is foggy, but that's what I remember.

Rich, N8UX

On Thu, Feb 26, 2015 at 4:57 AM, rrocket88 at netzero.net <
rrocket88 at netzero.net> wrote:

> here is an old descriptive i've had filed away, was going to perform but
> health went south  good luck K4IMZ
>
> http://home.windstream.net/ferncity/icom.htm
>
>
----
Your Moderator: Dick Flanagan K7VC: icom-owner at mailman.qth.net
Icom Users Net: Sundays, 1700Z, 14.316 MHz
Icom FAQ: http://www.qsl.net/icom/
To support QSL/QTH.net: http://www.qsl.net/donate.html