[ICOM] 765 freq problem

[Marc & Tricia Niebergall]

Rich,

Thanks for the additional info. It seems that the part numbers are pretty
scarce, so I would welcome any new info regarding availability of ceramic
trimmers.

Marc
On Feb 26, 2015 7:42 AM, "Rich Dailey" <redailey1 at gmail.com> wrote:

> I'm the author of that page. I need to mention that I'm not sure of the
> availablility of the replacement trimmers that are mentioned in the
> article. If someone has a good link to a supplier of substitutes, I'll
> update the page to add those links. Been a lot of years.
>
> Also, I'll throw in that I recall having one on the bench that had a
> sililar drift situation. I replaced the trimmers, AND
> 10uf bypass caps coming off a 5 volt regulator. They were pulling hard on
> that supply voltage. Seems
> it was on the board under the power supply, on a long, shared heat sink
> with other regulators. Like I said,
> it's been many years, my brain is foggy, but that's what I remember.
>
> Rich, N8UX
>
> On Thu, Feb 26, 2015 at 4:57 AM, rrocket88 at netzero.net <
> rrocket88 at netzero.net> wrote:
>
> > here is an old descriptive i've had filed away, was going to perform but
> > health went south  good luck K4IMZ
> >
> > http://home.windstream.net/ferncity/icom.htm
> >
> >
> ----
> Your Moderator: Dick Flanagan K7VC: icom-owner at mailman.qth.net
> Icom Users Net: Sundays, 1700Z, 14.316 MHz
> Icom FAQ: http://www.qsl.net/icom/
> To support QSL/QTH.net: http://www.qsl.net/donate.html
>