[ICOM] SM-5

[gfiber at comcast.net]

Doubtful, they likely do not know what an Icom SM-5 is. You could try Icom America, but generally parts for accessories were not available, but an odd chance they may have one. Other than that you will need to disassemble the mic so you can see the actual pot and match it up from online photo or in an electronics parts store. If you do not use that pot much you likely could substitute a fixed resistor or 2 depending if it is a voltage divider circuit in its place. You could also get a 10K pot and drill a hole in the mic base and use a more normal pot if it is small enough or a PCB mount that uses a screwdriver for adjusting it. 

Gary K8IZ 

----- Original Message -----

From: "Dan Cotsirilos" <k9dtc at comcast.net> 
To: "ICOM Reflector" <icom at mailman.qth.net> 
Sent: Tuesday, September 16, 2014 5:51:26 AM 
Subject: Re: [ICOM] SM-5 

If I call them they will know the one I need? 




Dan K9DTC 


-----Original Message----- 
From: Robert DiPippo 
Sent: Tuesday, September 16, 2014 7:48 AM 
To: ICOM Reflector 
Subject: Re: [ICOM] SM-5 

Jameco.com 


Bob 
On 09/16/2014 08:27 AM, Dan Cotsirilos wrote: 
> I have a SM-5 with a bad pot. The schematic shows 10K but does anyone know 
> where to get one? Is it a standard part? 
> 
> 
> Dan K9DTC 
> ---- 
> Your Moderator: Dick Flanagan K7VC: icom-owner at mailman.qth.net 
> Icom Users Net: Sundays, 1700Z, 14.316 MHz 
> Icom FAQ: http://www.qsl.net/icom/ 
> To support QSL/QTH.net: http://www.qsl.net/donate.html 
> 

-- 
Connecting the classroom to the world via technology © 
---- 
Your Moderator: Dick Flanagan K7VC: icom-owner at mailman.qth.net 
Icom Users Net: Sundays, 1700Z, 14.316 MHz 
Icom FAQ: http://www.qsl.net/icom/ 
To support QSL/QTH.net: http://www.qsl.net/donate.html 

---- 
Your Moderator: Dick Flanagan K7VC: icom-owner at mailman.qth.net 
Icom Users Net: Sundays, 1700Z, 14.316 MHz 
Icom FAQ: http://www.qsl.net/icom/ 
To support QSL/QTH.net: http://www.qsl.net/donate.html