[ICOM] Icom HT BNC Connector Wrench

[Walt - WB2VSJ]

You need some sort of pin spanner wrench or  "X key radio tool"  -  google
"X key radio tool" and you'll get a bunch of good hits

The next best bet is a pair on 90 deg bent needle nose pliers.  You may need
to do a bit of grinding to get them to fit the slots/groves around the BNC
connector.

Walt - WB2VSJ

-----Original Message-----
From: Icom [mailto:icom-bounces at mailman.qth.net] On Behalf Of D C _Mac_
Macdonald
Sent: Saturday, November 29, 2014 19:33
To: Icom Forum
Subject: [ICOM] Icom HT BNC Connector Wrench

Has anybody found a source for these?
  
* * * * * * * * * * *
* 73 - Mac, K2GKK/5 *
* (Since 30 Nov 53) *
* k2gkk hotmail com *
* Oklahoma City, OK *
* USAF & FAA (Ret.) *
* * * * * * * * * * * 
 

 		 	   		  
----
Your Moderator: Dick Flanagan K7VC: icom-owner at mailman.qth.net Icom Users
Net: Sundays, 1700Z, 14.316 MHz Icom FAQ: http://www.qsl.net/icom/ To
support QSL/QTH.net: http://www.qsl.net/donate.html