[ICOM] 756pro CI-V address

[joeduerbusch]

Ken if the address is the same in WL and your Icom and you are still having
problems, then it might be your Serial or USB=>Serial port.
Open your Writelog.ini file and find Rigs and remove the 2nd bit or change
it to 1 bit.  See example below:

[RIGS]
Com4:=9600,n,8,2  === Before
Com4 =9600,n,8,   === After.

Baud rate does not have to be 9600 but what ever you have the rig and WL
set to.

Joe K0BX
tu for all the RTTY QSO's over the years.



On Wed, Nov 12, 2014 at 1:08 AM, Jim Haynes <jhhaynes at earthlink.net> wrote:

> address 5C works for me.  However...yours may have been changed.
> Look in the manual under setting modes and see the one where you
> set the CI-V address.
>
> Jim W6JVE
>
>
> jhhaynes at earthlink dot net
>
> ----
> Your Moderator: Dick Flanagan K7VC: icom-owner at mailman.qth.net
> Icom Users Net: Sundays, 1700Z, 14.316 MHz
> Icom FAQ: http://www.qsl.net/icom/
> To support QSL/QTH.net: http://www.qsl.net/donate.html
>



-- 

#1 Honor Roll Mixed
Honor Roll RTTY
5BWAS

Stop the insanity!
Please do not add me to any distribution lists (Joke, Stories or Junk)
without my permission.