[ICOM] ICOM IC-03AT belt clip screw

[QTHnet-icom.K6PDG at ordinaryamerican.net]

Thank you, Gary. That's obviously vital information.

On Mon, Jun 2, 2014 at 2:01 PM, Gary Fiber - gfiber at comcast.net wrote:

> Sorry I do not remember the size but if you find one at a local hardware
> store, make sure you pay attention to the correct length. During my Icom
> years I have seen many handhelds come in where someone used a screw that
> was to long and ran it through the radio circuit board, likely unknowingly.
>
> Gary P. Fiber K8IZ
>
> > On Jun 2, 2014, at 11:22 AM, QTHnet-icom.K6PDG at OrdinaryAmerican.net
> wrote:
> >
> > Thanks, Larry
> >
> > 73
> > Patrick K6PDG
> >
> > On Mon, Jun 2, 2014 at 11:00 AM, Larry L. Hinton -
> hinton.ll at frontier.com
> > wrote:
> >
> >> The case screws are M2 x 0.4. If memory servers me, the belt clip
> screws are M4 x 0.7.
> >>
> >> As a suggestion, remove the other belt clip screw and use that as
> the model.
> >>
> >> As for sizes, as measured at the tip of the threads with a caliper:
> >>
> >> M2.5 x 0.45:    2.480 mm
> >> M3 x 0.50:       2.980 mm
> >> M3.5 x 0.6:      3.479 mm
> >> M4 x 0.70:       3.978 mm
> >>
> >> The above are "standard or JIS". Course threads are not used with screws
> >> below M10.
> >>
> >> Larry
> >> K7YBZ
> >>
> >>
> >> ________________________________
> >> From: "QTHnet-icom.K6PDG at OrdinaryAmerican.net"
> >> <QTHnet-icom.K6PDG at OrdinaryAmerican.net>
> >> To: icom at mailman.qth.net
> >> Sent: Monday, June 2, 2014 9:45 AM
> >> Subject: [ICOM] ICOM IC-03AT belt clip screw
> >>
> >>
> >> I've lost one of the screws that holds the belt clip to the HT. Does
> anyone
> >> know the size and thread pitch of those screws? The instruction manual
> only
> >> shows that there are two of them.
> >>
> >> I've already asked ICOM Technical Support. One of them replied he was
> >> unable to find the information.
> ----
> Your Moderator: Dick Flanagan K7VC: icom-owner at mailman.qth.net
> Icom Users Net: Sundays, 1700Z, 14.316 MHz
> Icom FAQ: http://www.qsl.net/icom/
> To support QSL/QTH.net: http://www.qsl.net/donate.html
>