[ICOM] HF Transceiver, PS, accessories, and many Icom items FS

[Ken Simpson, W8EK]

Icom items For Sale --
HF Transceiver, Power Supply, Desk Microphone,
Service Manual, Crystal Filter, Accessory
Cable, Voice Synthesizer, Original Boxes,
Cable / Adapter, Speaker Microphone, Charger
and DC Adapter, Manuals, and other Miscellaneous
Items


Icom IC-751 HF Transceiver:

The Icom IC-751 is an advanced transceiver covering 160 to
10 meters. It features a high performance 100 KHz to 30 MHz
general coverage receiver built in. Output is 10 to 100 watts
SSB/CW/RTTY modes (10 to 40 watts AM). The IC-751 has
sophisticated capabilities such as: dual digital VFOs,
all-mode squelch, Notch, Passband Tuning, RIT/XIT, pre-amp
and attenuator. You also get 32 memories. The two color
fluorescent digital display is easy to read. There is a
multi-function meter. Full and semi break-in CW capability.

Features:
All Mode
Analog S/RF Meter
180-10 Meters
All Mode Squelch
100 Hz Display
CW break-in
PBT
32 Memories
RIT/XIT
Noise Blanker
Notch

This particular unit is pristine. If the SK who had this unit used,it, 
it does not show. I have checked it out and of course it operates fine.

With paper work for $450.


Icom PS-30 Deluxe Metered Power Supply:

The Icom PS-30 power supply is a deluxe supply that delivers
13.8 VDC at 25 amps. This power supply features a meter which
can be set to display amperage or voltage. Four outputs are
provided on the rear panel. Output 1 is a hard wired, high
amperage cable with the Icom standard 6 pin Molex plug.
Outputs 2, 3 and 4 provide lower current 13.8 VDC output.
This power supply has a snap-out tilt bracket.
Size: 9.5 x 5 x 12.5 inches.

This particular supply works fine, and looks like new.
It is in its original box, with paper work. $200


Icom SM-6 microphone:

The Icom SM-6 is a unidirectional, electret microphone
designed for base station operation with many Icom
transceivers. The SM-6 features a switch for push to
talk and also a lock feature. There is a free-bending
neck for convenient adjustment. On the bottom of the
mic base there is a level adjustment. This mic is
powered from the Icom transceiver. The mic cable
terminates to a standard round Icom 8 pin mic plug.
This mic works with the Icom 28, 78, 271, 275, 471,
475, 718, 745, 746, 746 Pro, 756, 756 Pro, 756 Pro II,
775, 781, 900, 901, 970, 1275 and many others.

This one works 100% and looks very nice.  No scratches.
Wind screen included, along with paper work for $65.


Icom 751 Service Manual:

This is an original service manual for the IC-751.
It must be an inch thick!  It appears like it was
never used.  $28


Icom EX-310 Voice Synthesizer:

The EX-310 is used in many Icom rigs, including the IC-751,
IC-761, IC-271, IC-471, R-71 A, R-7000, and others. This
is a voice synthesizer that permits the frequency to to be
read out in a nice readable voice. It is ideal for blind
and sight impaired hams, but it is useful to anyone.

This particular unit is still in its original box, works 100%
and includes cables and paper work for hookup, all for $100.


Icom FL-52 A, 500 Hz Filter:

This is the "good one" with the steep shirts for
the 455 KHz IF. With the 500 KHz bandwidth it is
useful for narrow CW but it is also useful for
digital work as well.

It works with the IC-703, 718, 736, 737, 738, 740,
745, 746, 751, 751A, 756, 78, R75, R8500, and
likely others.

This one is in its original box, with original paper
work and hardware. I don't think it has ever been
used. There are not even finger prints on the filter!

AES sells this for $200. Buy this one in the same
condition for only $150.


Icom 24 pin accessory cable:

Icom uses a cable with a 24 pin molex connector on many
rigs for many purposes.  Additional pins can be added
for additional functions, if desired.  Consult the manual
for your rig for exact functions.

This cable was a gray, a yellow, and a red cable, each
with RCA phono connectors on them.  I think it was used
to interface digital modes, but I am not 100% certain
of that.

This one is in good shape.  $20


DC Power Cable

This is the heavy duty power cable as used on most of
the Icom HF rigs, plus also many Kenwood, Alinco, and others.
It has the 6 pin molex connector, with four pins used - two
for plus and two for ground.  The cable may not have ever
been used.  At least it looks good, and of course works
fine. $22


Original Boxes for Icom IC-2 AT, IC-22 and IC-27:

The original box for the IC-2 AT includes the styrofoam
insert that holds the HT, charger, and other accessories.
It even has the cardboard box for the charger with it.
It is in nice condition. $8

The box for the IC-22 A includes the two "clam shell"
styrofoam pieces that hold the rig and accessories.
It is in good shape. $8

The box for the IC-27 includes the two internal
styrofoam inserts that holds the rig, the cardboard
box for accessories that also acts as a spacer,
and even includes the original plastic bag for
the rig.
It is in nice condition. $10


Astron RS-20A Power Supply:

The RS-20A is a DC Power Supply producing 13.8 V DC (internally
adjustable from 11 to 15 V DC) at up to 16 amps continuous and
20 amps ICS. The RS-20 features crowbar over voltage protection
and fold-back current limiting to protect your equipment.

This particular supply works fine, and looks very close to new.
There is one very small scratch that can be seen if the light
is just right, but is not normally visible.

With paper work for $60.


Icom BC-72 A Desk Charger:

The Icom BC-72 A is a desk charger that will "fast charge"
the BP-81 thru BP-85 battery packs used in the "S" series
of HTs in about an hour or so.  This charger operates from
13 V DC with the supplied wall wart, but it can also be used
with a CP-12 DC cable from a cigarette lighter.

This particular unit works fine and is still in its original
box.  Of course paper work is included for $25.


Icom Battery Charger:

Icom BC-127 A, Battery Charger for Icom IC-Q7A Dual Band HT:
This charger charges two AA NiCads (or NiMH) for the
IC-Q7 A Dual band HT, and Icom R-2 receiver, and probably
others.
This appears to be new, unused, still in its bag.
Icom lists them at $21. Buy this one for $12.


Icom DC-1, 13 V DC adapter for many Icom HTs:
This adapter slides on the HT, in place of the battery
pack. If 13 V DC is applied, it converts the voltage to
the proper voltage for the HT.  It can be used with the
IC-2, IC-3, IC-4,IC-02, IC-03, IC-04, and others. This
one works fine, and looks very nice. With paper work for $18.


Icom CP-1 DC cord
This cord will work with the DC-1 above, plus many other
items needing the 2.1 mm coaxial power plug.  The opposite
end has a cigarette lighter plug on it.  $10


MFJ-284 HT Speaker Microphone:

This speaker mic has the 3.5 mm and 2.5 mm plugs on
it, as used by Icom, Alinco, Radio Shack, some Yaesu,
and many other HTs.

It works with the following:

YAESU 109, 209, 709, 23, 73, 33, 727 and other YAESU
radios which are pin compatible with the above rigs.

ICOM 2AT, 02AT, 3AT, 03AT, 4AT, 04AT, 12AT, u2A, u2AT,
u4AT and other ICOM radios which are pin compatible
with the above rigs.

ALINCO DJ-560 and other ALINCO radios which are pin c
ompatible with the DJ-560

RADIO SHACK - most

SANTEC ST-20

It works great, and looks like new.

With paper work for $15.


HT Belt Clips and Wrist Straps:

Belt Clips:
All include the hardware with the belt clip and are $6 each.
Icom IC-2 AT
Motorola
Yaesu FT-207
Yaesu FT-209

Wrist Straps for various HTs - $4 each
Kenwood TH-215 / 225 / 415, TR-2500, etc.
Kenwood TR-2400
Yaesu FT-209


Antennas for your HT:

All rubber ducks are for 2 meters, are in good condition,
and are $10 each, unless stated otherwise.

BNC - Original from Kenwood TH-215, about 5 inches long

BNC - Original Alinco EA0024 - 4 inches long

BNC "Stubby" about 4 1/2 inches long

BNC Connector, about 7 inches long

Type F connector - 6.5 inches long

BNC Stubby for 440 MHz, 3 inches long


ORIGINAL Icom operating manuals:

Please note that all of these are original Icom manuals
and are not copies. All are in very good condition.
These are original Icom manuals only.

Mobile transceiver manuals:
IC-22 A, 2 m FM transceiver, $10
IC-22 S, 2 m FM transceiver, $12
IC-27 A/E, 2 m transceiver, still in plastic bag, $15
IC-27 H, 2 m FM transceiver, $12
IC-28 H, 2 m FM transceiver, $12
IC-281 H, 2 m FM Transceiver $12
IC-290 H, 2 m FM transceiver, still in plastic bag, $15
IC-736/738, HF + transceiver, $20
IC-751, HF transceiver, still in plastic bag, $22
IC-3200 A/E, Dual Band FM Transceiver, $15

IC-751 HF Transceiver SERVICE manual, $28

Other Icom manuals:
BC-30 Desk Charger, $4
BC-35 Desk Charger, $5
BP-2, BP-3, BP-4, BP-5 battery packs, $3
BP-21, BP-22, BP-23, and BP-24 Batteries, $3
DC-1 DC pack for IC-2 AT series HTs, $4
EX-310 Voice Synthesizer, $5
HM-8 Hand Microphone, w/schematic, $5
HM-10 scanning microphone, $3
IC-3 PA Power supply / speaker, $10
RC-10 Frequency controller, $4
SM-5 desk microphone, $3
UT-16 Voice Synthesizer, $55

These are original Icom manuals only.


I also have many other accessories available such as many
different types of microphones, HTs, HF, VHF and UHF rigs,
HF and VHF/UHF antennas, HF linear amplifiers, and many
other accessories.
Just too many to list here. Please e-mail your requests.


Prices do not include shipping from Florida.

Thanks.

73,

Ken, W8EK

Ken Simpson
E-mail to W8EK at FLHam.net or W8EK at arrl.net
Voice Phone (352) 732-8400