[ICOM] Icom Items FS - Dual Band Multimode Xcvr, PS, and much more

Sat Aug 3 17:33:42 EDT 2013

Icom items For Sale --
Dual Band Multimode VHF/UHF Transceiver, Crystal
Filter, Accessory Cable, Power Supply, Voice
Synthesizer, Original Boxes, Cable / Adapter,
Speaker Microphone,  Charger and DC Adapter,
Manuals, and other Miscellaneous Items

Icom IC-820 H, Dual Band Multimode Transceiver:

The IC-820 is a multimode unit covering FM, SSB, and CW.
It has output of 45W SSB, 35W FM/CW on 144-148 MHz, and
40W SSB, 30W FM/CW on 430-450 MHz.

Although it works great for terrestrial FM and SSB, it is
also great for satellite operation which includes normal
and reverse tracking and independent uplink/downlink
control for Doppler shift compensation. Separate satellite
VFO and 10 satellite memories provide quick switching
from normal to satellite operation. It has independent
controls and indications for both bands.

Features:
Multimode
116 Memories
Call Channel
Speech compression
IF shift
Dual Digital VFOs
Satellite Functions
9600 baud Compatible
Requires 13 V DC at 16 amps

This particular unit works 100% and looks close to the
same. Pristine. No scratches. DTMF mic, power cord,
and paper work included for $600.

Icom FL-52 A, 500 Hz Filter:

This is the "good one" with the steep shirts for
the 455 KHz IF. With the 500 KHz bandwidth it is
useful for narrow CW but it is also useful for
digital work as well.

It works with the IC-703, 718, 736, 737, 738, 740,
745, 746, 751, 751A, 756, 78, R75, R8500, and
likely others.

This one is in its original box, with original paper
work and hardware. I don't think it has ever been
used. There are not even finger prints on the filter!

AES sells this for $200. Buy this one in the same
condition for only $150.

Icom 24 pin accessory cable:

Icom uses a cable with a 24 pin molex connector on many
rigs for many purposes.  Additional pins can be added
for additional functions, if desired.  Consult the manual
for your rig for exact functions.

This cable was a gray, a yellow, and a red cable, each
with RCA phono connectors on them.  I think it was used
to interface digital modes, but I am not 100% certain
of that.

This one is in good shape.  $20

Icom PS-30 Deluxe Metered Power Supply:

The Icom PS-30 power supply is a deluxe supply that delivers
13.8 VDC at 25 amps. This power supply features a meter which
can be set to display amperage or voltage. Four outputs are
provided on the rear panel. Output 1 is a hard wired, high
amperage cable with the Icom standard 6 pin Molex plug.
Outputs 2, 3 and 4 provide lower current 13.8 VDC output.
This power supply has a snap-out tilt bracket.
Size: 9.5 x 5 x 12.5 inches.

This particular supply works fine, and looks very close to new.
It is in its original box, with paper work. $200

Icom EX-310 Voice Synthesizer:

The EX-310 is used in many Icom rigs, including the IC-751,
IC-761, IC-271, IC-471, R-71 A, R-7000, and others. This
is a voice synthesizer that permits the frequency to to be
read out in a nice readable voice. It is ideal for blind
and sight impaired hams, but it is useful to anyone.

This particular unit is still in its original box, works 100%
and includes cables and paper work for hookup, all for $100.

Original Boxes for Icom IC-2 AT, IC-22 and IC-27:

The original box for the IC-2 AT includes the styrofoam
insert that holds the HT, charger, and other accessories.
It even has the cardboard box for the charger with it.
It is in nice condition. $8

The box for the IC-22 A includes the two "clam shell"
styrofoam pieces that hold the rig and accessories.
It is in good shape. $8

The box for the IC-27 includes the two internal
styrofoam inserts that holds the rig, the cardboard
box for accessories that also acts as a spacer,
and even includes the original plastic bag for
the rig.
It is in nice condition. $10

Astron RS-20A Power Supply:

The RS-20A is a DC Power Supply producing 13.8 V DC (internally
adjustable from 11 to 15 V DC) at up to 16 amps continuous and
20 amps ICS. The RS-20 features crowbar over voltage protection
and fold-back current limiting to protect your equipment.

This particular supply works fine, and looks very close to new.
There is one very small scratch that can be seen if the light
is just right, but is not normally visible.

With paper work for $60.

MFJ-284 HT Speaker Microphone:

This speaker mic has the 3.5 mm and 2.5 mm plugs on
it, as used by Icom, Alinco, Radio Shack, some Yaesu,
and many other HTs.

It works with the following:

YAESU 109, 209, 709, 23, 73, 33, 727 and other YAESU
radios which are pin compatible with the above rigs.

ICOM 2AT, 02AT, 3AT, 03AT, 4AT, 04AT, 12AT, u2A, u2AT,
u4AT and other ICOM radios which are pin compatible
with the above rigs.

ALINCO DJ-560 and other ALINCO radios which are pin c
ompatible with the DJ-560

RADIO SHACK - most

SANTEC ST-20

It works great, and looks like new.

With paper work for $15.

Icom Battery Charger:

Icom BC-127 A, Battery Charger for Icom IC-Q7A Dual Band HT:
This charger charges two AA NiCads (or NiMH) for the
IC-Q7 A Dual band HT, and Icom R-2 receiver, and probably
others.
This appears to be new, unused, still in its bag.
Icom lists them at $21. Buy this one for $12.

Icom DC-1, 13 V DC adapter for many Icom HTs:
This adapter slides on the HT, in place of the battery pack.
If 13 V DC is applied, it converts the voltage to the proper
voltage for the HT.  It can be used with the IC-2, IC-3, IC-4,
IC-02, IC-03, IC-04, and others. This one works fine, and
looks very nice.  With paper work for $18.

Icom CP-1 DC cord
This cord will work with the DC-1 above, plus many other items needing 
the 2.1 mm coaxial power plug.  The opposite end has a cigarette 
lighter plug on it.  $10

HT Belt Clips and Wrist Straps:

Belt Clips:
All include the hardware with the belt clip and are $6 each.
Icom IC-2 AT
Motorola
Yaesu FT-207
Yaesu FT-209

Wrist Straps for various HTs - $4 each
Kenwood TH-215 / 225 / 415, TR-2500, etc.
Kenwood TR-2400
Yaesu FT-209

Antennas for your HT:

All rubber ducks are for 2 meters, are in good condition,
and are $10 each, unless stated otherwise.

BNC - Original from Kenwood TH-215, about 5 inches long

BNC - Original Alinco EA0024 - 4 inches long

BNC "Stubby" about 4 1/2 inches long

BNC Connector, about 7 inches long

Type F connector - 6.5 inches long

BNC Stubby for 440 MHz, 3 inches long

ORIGINAL Icom operating manuals:

Please note that all of these are original Icom manuals
and are not copies. All are in very good condition.
These are original Icom manuals only.

Mobile transceiver manuals:
IC-22 A, 2 m FM transceiver, $10
IC-22 S, 2 m FM transceiver, $12
IC-27 A/E, 2 m transceiver, still in plastic bag, $15
IC-27 H, 2 m FM transceiver, $12
IC-28 H, 2 m FM transceiver, $12
IC-281 H, 2 m FM Transceiver $12
IC-290 H, 2 m FM transceiver, still in plastic bag, $15
IC-736/738, HF + transceiver, $20
IC-751, HF transceiver, still in plastic bag, $25
IC-3200 A/E, Dual Band FM Transceiver $15

Other Icom manuals:
BC-30 Desk Charger, $4
BC-35 Desk Charger, $5
BP-2, BP-3, BP-4, BP-5 battery packs, $3
BP-21, BP-22, BP-23, and BP-24 Batteries, $3
DC-1 DC pack for IC-2 AT series HTs, $4
EX-310 Voice Synthesizer, $5
HM-8 Hand Microphone, w/schematic, $5
HM-10 scanning microphone, $3
IC-3 PA Power supply / speaker, $10
RC-10 Frequency controller, $4
SM-5 desk microphone, $3
UT-16 Voice Synthesizer, $55

These are original Icom manuals only.

I also have many other accessories available such as many
different types of microphones, HTs, HF, VHF and UHF rigs,
HF and VHF/UHF antennas, HF linear amplifiers, and many
other accessories.
Just too many to list here. Please e-mail your requests.

Prices do not include shipping from Florida.

Thanks.

73,

Ken, W8EK

Ken Simpson
E-mail to W8EK at FLHam.net or W8EK at arrl.net
Voice Phone (352) 732-8400