[ICOM] Spkr Mics, Charger, Manuals, Dummy Load and more FS

[Ken Simpson, W8EK]

Speaker Microphones, Charger, Manuals, Dummy Load,
and other Miscellaneous For Sale:


HT Speaker Microphones:

All of these have the 3.5 mm and 2.5 mm plugs on them,
as used by Icom, Alinco, Radio Shack, some Yaesu, and
other HTs.

Pryme Speaker Microphone
It works fine and look line new. $20

Azden SDX-316
This is the rounder style speaker mic that fits nicely in
the palm of your hand. $ 20

MFJ-287 Speaker Microphone
This fits the TH-21/31/41 series HTs, TH-205, TH-215, TH-415,
as well as others. It has a 3 conductor 3.5 mm plug and a 2
conductor 2.5 mm plug.
It works fine, and looks close to new. $15


Icom Battery Charger:

Icom BC-127 A, Battery Charger for Icom IC-Q7A Dual Band HT:
This charger charges two AA NiCads (or NiMH) for the
IC-Q7 A Dual band HT, and Icom R-2 receiver, and probably
others.
This appears to be new, unused, still in its bag.
Icom lists them at $21. Buy this one for $12.


Icom DC adapter:

Icom DC-25
This is a pack that is used on the Icom µ2AT, Icom µ4AT, and
on other HTs that use the BP-20, BP-21, BP-22, BP-23 and BP-24
battery packs.  It takes 13 V DC (such as from a cigarette
lighter), and converts it to the 9.4 V DC voltage needed for
the HT.  It is used in place of a battery.  This one works
fine and looks fine.  $18


Wall Wart Power supplies:

All are standard "non-switching" types, with no noise like
the switching types have.

AEA AC-1 "Wall Wart" Power Supply
This "Wall wart" power supply will supply 12 V DC at
up to 1 amp.
It can be used with the AEA PK-232, PK-88 or others.
This unit has a 2.1 mm plug, with the center positive,
so it can be used on many different things that require
12 V DC at up to an amp, such as keyers, antenna tuners,
etc. $14

Yaesu NC-18 B Charger
Provides 14.5 V DC at 50 ma to charge many different HTs,
including the Yaesu FT-411, FT-811, FT-911, FT-23, FT-209,
FT-415, FT-410, FT-470, FT-727, FT-530, FT-703, and more.
Small 2.5 mm male plug. $10


ORIGINAL Icom operating manuals:

Please note that all of these are original Icom manuals
and are not copies. All are in very good condition.
These are original manuals only.

BC-30 Desk Charger $5
BC-35 Desk Charger $7
BP-2, BP-3, BP-4, BP-5 battery packs $3
BP-21, BP-22, BP-23, and BP-24 Batteries $3
DC-1 DC pack for IC-2 AT series HTs $4
HM-8 Hand Microphone, w/schematic $5
IC-22 S, 2 m FM transceiver $12
IC-28 H, 2 m FM transceiver $12
IC-3 PA Power supply / speaker $10
UT-16 Voice Synthesizer $5

These are original manuals only.


Heath HN-31 "Cantenna" RF Dummy Load:

This is the traditional Heath dummy load that will handle a
kilowatt. It has a derating curve both printed in the manual
and on the can.

It is in good shape both electrically and cosmetically. The
cantenna has no rust, dents or dings.

I can ship it either with or without oil. The cost to purchase
is the same, but of course the shipping will be higher with
the oil.

Paper work is included for $40.


Low Pass TVI Filters:

A low pass TVI filter is added to the transmitter to reduce
harmonic interference. All have SO-239 connectors, are 50
ohm filters, and include paper work.

Bencher YA-1, high power, low pass TVI filter
If you need a more heavy duty filter for the output of
your amplifier, this one is ideal. It will take full legal
power plus, and has at least 80 db signal attenuation at
TV channel 2.
This one works great, and looks close to new. Bencher
currently sells these for about $90. Only $60.

Drake TV-1000-LP Low pass TVI filter
This is the filter that may also be used on the low end of six
meters, as well as HF. It is good for 1000 W "average" below 30
MHz, and about 200 W up to 52 MHz. $30.

Drake TV-3300-LP Low Pass Filter
This modern low pass filter has been optimized to have more
attenuation in the 40 MHz region, where many TVs have their
IF. It is good for 1000 Watts "average" according to the manual,
and has over 80 db attenuation at 41 MHz. This one looks great,
and includes the paper work. $30

B & W FL-10/1500
This filter cuts off just above 10 meters, and handles 1500
Watts. It is the latest model B&W filter.
In very nice condition, it looks close to new. $40.

Para Dynamics PDC 1089
This filter is rated at a full Kilowatt, up to 30 MHz.
5 x 6 x 2 inch black box, instead of the more familiar long
enclosure. It looks like new. $25

Johnson 250-20 Low Pass Filter
This is a 52 ohm cylindrical low pass filter with a cut
off frequency of 45 MHz and 75 db of attenuation.
It is rated to take 1000 Watts of AM, or 5000 Watts
PEP SSB. With mounting bracket. $30


Coax connectors and adapters:

Prices are per connector. Several of each are available.
It looks like these have not been used.

"N" Connector - Double Male $8

BNC male for coax cable
standard type $2
crimp on type $3

Chassis mount BNC female
square mount (uses 4 screws) $3
screw in type $3

BNC "T" - two female and one male $3

Antenna adapter to fit the BNC connector on the HT
and provide an SO-239 connector that will permit
a PL-259 to be attached. (BNC male to UHF female) $5

UHF Male (PL-259) to BNC female (opposite of above) $5

UHF double female "Barrel connector" (two SO-239 together) $3

UHF "Bulkhead Connector" - Double female, as above, but for
mounting thru a window, siding, etc. about 3 inches long $6

UHF double male connector (two PL-259's together) $3

UHF "T" connector with two female (SO-239) and one male
(PL-259) connection $5


I also have many other accessories available such as many
different types of microphones, HTs, HF, VHF and UHF rigs, HF
and VHF/UHF antennas, etc.
Just too many to list here. Please e-mail your requests.


Prices do not include shipping from Florida.

Thanks.

73,

Ken, W8EK

Ken Simpson
E-mail to W8EK at FLHam.net or W8EK at arrl.net
Voice Phone (352) 732-8400