[ICOM] Information sufficient now ... THANKS!!

[Larry Young]

San: Have you tried  http://www.thepartsplace.k5nwa.com/index.php?route=product/product&product_id=63
Good luck. Larry K4LXV

--- On Mon, 8/13/12, hamop <k5yy at cox.net> wrote:

From: hamop <k5yy at cox.net>
Subject: [ICOM] Information sufficient now ... THANKS!!
To: "ICOM Reflector" <icom at mailman.qth.net>
Date: Monday, August 13, 2012, 11:59 PM

Icom Reflector group:
   I have enough information now on adjusting the bias on the soon to be 
replaced driver. The information from VA7OJ coupled with two of your 
procedures for adjusting the bias current ( 1 amp per device ), slightly 
varying in how and where to read the current,  will allow us to get the job 
done.  Unfortunately RF Parts wants a minimum order of $25 plus shipping, 
and Chinese vendors only want $3 each plus $3 shipping, but there is a 14 
day shipping delay getting the parts to me. A local person has the drivers 
but we can not get them yet (long story), so we are without drivers. I 
wanted two, one for a future backup, in case the currently working one 
becomes defective. Again, THANKS to those who replied.
73
San K5YY

-----Original Message----- 
From: hamop
Sent: Thursday, August 09, 2012 4:45 PM
To: icom at mailman.qth.net
Subject: [ICOM] bias setting on driver RD15HVF1

Group:
   Have one of the drivers out on the PROIII, the RD15HVF1. I do NOT have a 
tech manual. When I have installed the new driver transistor what is the 
bias setting procedure?
San K5YY   ( late model 756 PROIII with MOSFETs, not bipolar finals )

----
Your Moderator: Dick Flanagan K7VC: icom-owner at mailman.qth.net
Icom Users Net: Sundays, 1700Z, 14.316 MHz
Icom FAQ: http://www.qsl.net/icom/
To support QSL/QTH.net: http://www.qsl.net/donate.html