[ICOM] IC-7000 and Better RF antenna controller

[Gary P. Fiber]

Any one running the combination of IC-7000 and the 2 piece Better RF 
Screwdriver antenna controller combination along with one of the 
screwdriver antennas?
I have it operating my HS-1800/PRO antenna. It works fine some days and 
some days is seems to have lost its mind and will not find a low SWR point.
Yesterday I turned it off hitting the tune button and in a few moments 
it turned back on and put the rig into transmit and moved the antenna to 
one end of its travel.
I will do a reset this weekend and go after it again.  Likely I need to 
do more bonding on my 2009 Tacoma but sure seems to be apparently 
bothered by any possible RFI and I don't notice any in my other equipment.

Another question have any of you used a similar combination using the 
N2VZ turbo Tuner?  Are you happy with either?

I actually got spoiled using the IC-706MKII non G model with the 
HS-1800/PRO and the AN-COMM controller it mostly never missed a beat 
unless I hosed it up a few times.
Then a quick reset and I was back in business and I did not have every 
piece of the vehicle bonded when using that combination.
Had that combination for probably 9 years running on 3 different vehicles.

-- 
Gary P. Fiber K8IZ

General Radio Telephone Operators License PG-19-6691,
with Shipboard Radar Endorsement.
Washington State Resident.

Confidentiality Notice: This e-mail message, including any attachments, is for the sole use of the intended recipient (s) and may contain confidential and privileged information.
Any unauthorized review, use, disclosure or distribution is prohibited. If you are not the intended recipient, please contact the sender by reply e-mail and destroy all copies of the original message.