[ICOM] IC-7656 Pro 3 Question

[Conrad & Kathi Nasatka]

Larry:
It says in the SignaLink USB instructions to turn Vox off.
I am still getting used to the rig as I only received it on about 1/25/2011.
The SignaLink is connected to the rig via an 8 pin din into acc #1.
The computer has a line going into the USB port on the computer.
The speakers are salso wired into the SignaLink USB.
When i key the program to send a red light comes on the SignaLink USB but it 
doesn't key the transmitter.
I tried pushing the transmit button but nothing happens. There is a tune 
button on the program and I tested it and the
red light comes on but no transmitter keying.  I pushed the LSB twice to get 
the LSB D mode or digital mode.
I am out of ideas, got any more? It is r  unning in digital mode all the 
time.
Regards
Conrad
WB3DQD

----- Original Message ----- 
From: "Larry Young" <k4lxv at bellsouth.net>
To: "ICOM Reflector" <icom at mailman.qth.net>
Sent: Thursday, February 17, 2011 10:50 PM
Subject: Re: [ICOM] IC-7656 Pro 3 Question


> Conrad: While not at all familiar with EasyPal, most software via sound 
> card to the radioprograms require some type of hardware interface to 
> actually key the transmitter. If attempting to run the digital input via 
> the rear panel or the front audio input in digital mode you most definate 
> hardware means to implement the ptt of the proIII. Rhe radio vox operates 
> only via the front panel mic input, but not in digital mode.
> Larry K4LXV
>
> --- On Thu, 2/17/11, Conrad & Kathi Nasatka <konco at ptd.net> wrote:
>
> From: Conrad & Kathi Nasatka <konco at ptd.net>
> Subject: [ICOM] IC-7656 Pro 3 Question
> To: "ICOM Reflector" <icom at mailman.qth.net>
> Date: Thursday, February 17, 2011, 6:16 PM
>
> I recently purchased an ICOM 756 Pro 3 and am having problems getting
> Easy Pal to key the transmitter.
> I am hoping I can get an answer from someone on the list
> Regards
> Conrad
> WB3DQD
> ----
>
> ----
> Your Moderator: Dick Flanagan K7VC: icom-owner at mailman.qth.net
> Icom Users Net: Sundays, 1700Z, 14.316 MHz
> Icom FAQ: http://www.qsl.net/icom/
> To support QSL/QTH.net: http://www.qsl.net/donate.html
>