[ICOM] IC756 Pro receive input dead?

[Jamie WW3S]

Thanks for the tip Jim, you were exactly right....and ICOM dead wrong, I guess....when plugged into the jack labeled tranverter, all works FB.....thanks again and 73
Jamie WW3S
On 2/5/2011 8:15:14 PM, Jim Vohland (n9vo at hotmail.com) wrote:
> You may want to check this. On my 756 pro, the manual shows the rx antenna
> jack is the one on the far right (looking from the front of the radio).
> Mine actually is the one to the left of that.......Try and see.....But it
> works on my pro. I am using a beverage and thats the jack that works. Not
> the one the manual says.....
> 
> > From: ww3s at zoominternet.net
> > To: icom at mailman.qth.net
> > Date: Sat, 5 Feb 2011 16:55:26 -0500
> > Subject: [ICOM] IC756 Pro receive input dead?
> >
> > Trying to use the separate rx input (RCA jack) on the rear panel.....I
> have the ant switch set for 1/R, which I think means the separate RX jack
> is on, but it seems dead, do I have to turn something else on? Is this
> input protected by something that may be blown?
> > ----
> > Your Moderator: Dick Flanagan K7VC: icom-owner at mailman.qth.net
> > Icom Users Net: Sundays, 1700Z, 14.316 MHz
> > Icom FAQ: http://www.qsl.net/icom/
> > To support QSL/QTH.net: http://www.qsl.net/donate.html
> 
> ----
> Your Moderator: Dick Flanagan K7VC: icom-owner at mailman.qth.net
> Icom Users Net: Sundays, 1700Z, 14.316 MHz
> Icom FAQ: http://www.qsl.net/icom/
> To support QSL/QTH.net: http://www.qsl.net/donate.html
> 
> 
> 
> -----
> No virus found in this message.