[ICOM] Wanted: Narrower (than stock) SSB filter for IC-735

[Gary P. Fiber]

I want to say the FL-30 was the original SSB filter nut would have to 
find a print and have a look. I suspect one of your choices will be 
Inrad but it will not likely be a drop in, you may have to use some 
RG-174 to connect it up and some double stick tape to mount it.  
Possibly W4RT has a collins mechanical filter that would work too. I 
don't think the Icom FL-223 1.8 KHz filter will work as the impedance 
for the filter is likely wrong for the 735 circuit. And it has plug in 
leads where the IC-735 lead placement likely will not match and the 
original filter is a solder in type.

Gary K8IZ

On 8/21/2011 5:45 PM, D C *Mac* Macdonald wrote:
> Subject line says most all of it. I'm looking for an
> improvement for SSB selectivity at a reasonable(?) cost.
>
> * * * * * * * * * * *
> * 73 - Mac, K2GKK/5 *
> * (Since 30 Nov 53) *
> * Oklahoma City, OK *
> * USAF, Ret (61-81) *
> * * * * * * * * * * *
>
>
>    		 	   		
> ----
> Your Moderator: Dick Flanagan K7VC: icom-owner at mailman.qth.net
> Icom Users Net: Sundays, 1700Z, 14.316 MHz
> Icom FAQ: http://www.qsl.net/icom/
> To support QSL/QTH.net: http://www.qsl.net/donate.html
>


-- 
Gary Fiber K8IZ
GROL PG-19-6691 with shipboard radar endorsement
Washington State resident