[ICOM] Icom DTMF Mics, Bat Packs, Manuals and other items FS

Sat Sep 11 18:18:59 EDT 2010

Icom DTMF Touch Tone Hand Microphones, plus an assortment
of manuals, plus other items For Sale:

Icom HM-8 hand mic with Touch Tone (DTMF) Pad:
The HM-8 has a 12 digit touch tone (DTMF) pad on the front
of it, along with an on-off switch for the tones. Of course
it also has the normal PTT switch.
The HM-8 is used on the 25A Red LED, 245, 290, 402, 202S,
451, 471A, plus other rigs.
This particular microphone has an 8 pin round connector,
works fine, and includes paper work for $40.

Icom HM-8 hand mic that needs repair:
This mic is being sold for repair or for parts only. The dynamic
element in it is open. The actual touch tone pad and electronics
is OK. So if you have an HM-8 with bad electronics or actual
touch tone pad, this unit will get you up and going again.
Actually, the unit probably can be repaired by adding a dynamic
mic element. $22

Dead Battery Packs:

Please note that all of these battery packs are dead. There
is no voltage from them. They are being sold for the purpose
of rebuilding, or to be used to build a regulator in them,
or whatever.

Batteries for Icom 2AT, 3 AT, 4 AT, 02AT, 03AT. 04AT, 24,
and others:
BP-2, looks very nice $5
BP-3, looks like it may have gotten warm, and may be slightly
deformed $4
BP-4, "Empty case" for alkalines, etc. Needs cleaning. $8
BP-5, larger pack, looks good, but has former owners call
sign scratched in case, $5
Buy all four of the above for $20.

ORIGINAL Icom operating manuals:

Please note that all of these are original Icom manuals and
are not copies. All are in very good condition.
These are original manuals only.

BC-30 Desk Charger $5
BC-35 Desk Charger $7
BP-2, BP-3, BP-4, BP-5 battery packs $3
BP-21, BP-22, BP-23, and BP-24 Batteries $3
DC-1 DC pack for IC-2 AT series HTs $4
HM-8 Hand Microphone, w/schematic $5
IC-22 S, 2 m FM transceiver $12
IC-3 PA Power supply / speaker $10
UT-16 Voice Synthesizer $5

These are original manuals only.

MFJ 249 Antenna Analyzer:

This antenna analyzer covers from 1.8 to 170 MHz, so it covers
all of the HF bands, plus 6 and 2 meters.

Use this unit to find your antennas true resonant frequency.
Trim dipoles and verticals. Adjust your Yagi, quad, loop and
other antennas, change antenna spacing and height and watch
SWR, resistance and reactance change instantly. Perfectly tune
critical HF mobile antennas in seconds. Take the guesswork out
of building and adjusting matching networks and baluns. You can
determine velocity factor, coax cable loss in dB, length of coax
and distance to a short or open in feet. You can read SWR, return
loss and reflection coefficient. Two line LCD screen clearly
displays your information. Built-in frequency counter.

This particular unit works fine, and looks extremely nice.
With paper work for $150.

MFJ 815 Cross Needle Wattmeter
The MFJ-815 cross-needle meter allows you to monitor both
forward and reflected power, and SWR simultaneously. There
are buttons to select power ranges of 20/200/2000 watts
forward and 5/50/500 watts reflected.
Frequency coverage is 1.8 to 60 MHz, so it covers 6 meters
in addition to the HF bands, making it ideal for some of
the new rigs that include 6 meters.
There is a meter light that requires a source of 12 V DC.
This particular unit works fine, and looks extremely good.
With paper work for $50.

M C Jones VHF/UHF Wattmeter:
This MC Jones Wattmeter is a vintage unit, probably from just
after WW II. At that time, it was the gold standard of wattmeters,
basically equivalent to a Bird today.
This particular meter has N connectors in and out. It reads 12
Watts full scale in the forward position, and 4 Watts full scale
in reflected. It also has an SWR calibrate and SWR scale on the
meter. I think the frequency range is from 20 to 1000 MHz, but I
am not 100% positive of that. It works well on 2 meters and 440
MHz. The RF sensor unit inside is model 576.3.
This one functions fine, and looks extremely nice for its age.
$60

SWR Bridge for HF and VHF:
Quement SWB-2 Dual Meter SWR Bridge
This unit features two separate meters -- one for reading forward
power and another for reading SWR. This permits one to easily
monitor both the power going out, and the SWR on the antenna.
It has SO-239 connectors on each end.
It will work on HF, and VHF, covering 3 to 150 MHz, so is
ideal for the new rigs that include 6 and 2 meters.
This particular unit works fine and looks great.
With paper work for $40.

Astron RS-12 A, 13.8 Volt DC Power Supply:
This power supply is rated at 9 amps continuous and 12 amps ICS.
It is ideal for most 2 meter rigs, including the 50 Watt rigs.
This Astron power supply features solid-state electronic
regulation, EMI filter, fold back current limiting for protection
from excessive current and shorted output, and crowbar over-voltage
protection.
This particular supply works 100% and looks the same. I can not find
a scratch on it. With paper work for $50.

Prices do not include shipping from Florida.

Thanks.

73,

Ken, W8EK

Ken Simpson
E-mail to W8EK at FLHam.net or W8EK at arrl.net
Voice Phone  (352) 732-8400

__________ Information from ESET NOD32 Antivirus, version of virus signature database 5443 (20100911) __________

The message was checked by ESET NOD32 Antivirus.

http://www.eset.com