[ICOM] 756 pro III noise

[Walt Heilsnis - WB2VSJ]

This is beginning to sound a little bit familiar - I vaguely remember something somewhere about a transmit issue like this and I think it was Auto-Tuner related. 

Anyway, according to the PRO III Manual the reset procedure is:

- Make sure the transceiver power is OFF.
- While pushing [M-CL] and [(F-INP)ENT], push
[POWER] to turn power ON.
- The internal CPU is reset.
- A/D convertor calibration of the DSP unit starts and it
takes 10 sec.
- The transceiver displays its initial VFO frequencies when
resetting is complete.
- Correct the set mode settings after resetting, if desired.

I have a PRO II and have not had any issues like this (yet) :)

Walt


-----Original Message-----
>From: Jaime Gomez <cwdx.hk1n at gmail.com>
>Sent: Oct 13, 2010 1:07 PM
>To: ICOM Reflector <icom at mailman.qth.net>
>Subject: Re: [ICOM] 756 pro III noise
>
>Hi Walt, I have connected a dummy load to the antenna terminal, no change,
>noise is present in all bands, all modes, not affected by attenuators or
>preamps, all other radios in the station (7800, proII, proIII, 781) work
>fine. I just noticed also that it is not transmitting, the Tx red light just
>blinks and turns off and no power output.
>
>How do I hard reset the rig to factory fresh as Rich sugested?
>
>Thanks, 73
>