[ICOM] ??Screws??

[ZL2AAA]

If they are the same as Prolll etc they are 3mm .5 pitch(coarse)
----- Original Message ----- 
From: "Marc Ecker" <mecker at peoplepc.co
m>
To: "ICOM Reflector" <icom at mailman.qth.net>
Sent: Thursday, November 18, 2010 6:07 PM
Subject: Re: [ICOM] ??Screws??


> they don't. Need sizes and lengths to find an alternate.
>
> --------------------------------------------------
> From: "Gary P. Fiber" <gfiber at comcast.net>
> Sent: Wednesday, November 17, 2010 11:41 PM
> To: "ICOM Reflector" <icom at mailman.qth.net>
> Subject: Re: [ICOM] ??Screws??
>
>> Icom should have them Marc. I am not exactly sure but i think there were
>> some difference in lengths. The case screws used to be painted brass
>> screws too.
>>
>> Gary K8IZ
>>
>> On 11/17/2010 6:26 PM, Marc Ecker wrote:
>>> Am looking for the short screws that work in the  IC-781,  R-9000, and
>>> IC-7800.
>>> Need about two dozen of them. (not the ones that work for rack handles)
>>> Does anyone know what the thread size is and length of these screws?
>>>
>>> ----
>>> Your Moderator: Dick Flanagan K7VC: icom-owner at mailman.qth.net
>>> Icom Users Net: Sundays, 1700Z, 14.316 MHz
>>> Icom FAQ: http://www.qsl.net/icom/
>>> To support QSL/QTH.net: http://www.qsl.net/donate.html
>>>
>>
>>
>> -- 
>> Gary Fiber K8IZ
>> GROL PG-19-6691 with shipboard radar endorsement
>> Washington State resident
>>
>> ----
>> Your Moderator: Dick Flanagan K7VC: icom-owner at mailman.qth.net
>> Icom Users Net: Sundays, 1700Z, 14.316 MHz
>> Icom FAQ: http://www.qsl.net/icom/
>> To support QSL/QTH.net: http://www.qsl.net/donate.html
> ----
> Your Moderator: Dick Flanagan K7VC: icom-owner at mailman.qth.net
> Icom Users Net: Sundays, 1700Z, 14.316 MHz
> Icom FAQ: http://www.qsl.net/icom/
> To support QSL/QTH.net: http://www.qsl.net/donate.html