[ICOM] IC735 VCO caps... the real story.

[Gary Fiber]

My experience,

I am unaware of any cut off serial number for the IC-735 VCO trim 
caps.That rig never came with ceramic dielectric trim  caps so far as I 
remember.
I am not sure we at Icom America ever actually discovered the problem 
with the plastic trimmer caps. One school of thought was the wax used to 
deaden microphonics within the VCO had got into the original caps when 
the factory poured it in. The DC voltage is so low within the VCO 
circuit I am sure its not due to the caps being over voltage being 
applied. But still the plastic trim caps do go bad and replacement fixes 
the problem either with new plastic dielectric or ceramic dielectric 
caps. I do not remember the factory ever changing to a ceramic based 
cap. Remember there were some 40,000 IC-735's produced world wide and 
its very likely a lot of them have never had this problem as some here 
on this forum attest to.
Several Icom's used the same design. The IC-M700 marine SSB transceiver 
used the same VCO and no trim cap issues with those so far as I 
remember, they also came standard with the CR-64 as the Part 80 to end 
technical rules state a marine SSB transceiver needs to be with in 20 Hz 
of the transmit frequency its supposed to be transmitting on, much 
tighter specs than an amateur transceiver has. Still that's not the 
answer to the caps going bad. I suspect it may be the wax though it 
seems to me the VCO never gets warm enough for the wax to melt during 
operation to migrate up into the caps.
  IC-735, 745, 751 / A, 761. R71, M700. M700TY, 271 A /H , 471 A/H all 
used the plastic dielectric trimmer caps some more extensively than 
others. I may have missed a rig or two also.

Gary K8IZ



On 2/27/2010 4:08 PM, C.Whitaker wrote:
> de WB2CPN
> Here's one to mull over.
> Some years ago I bought an IC-751 from one
> of the smaller wholesalers in NJ, and it was
> understood at the time that radio was new,
> and I was the first owner.  Some years later
> the VCO scare (?) came out, and I opened
> the radio to have a look because there was
> a shiny metal shield that would be removed,
> and re soldered when the replacement job
> was complete.  Well, that radio already had
> that shield resoldered at one time or another.
> Tweren't me.  The wholesaler said it must have
> come from ICOM that way because he didn't
> do it.  How do you figure that?
> 73  Clete
>
>
>
> ----
> Your Moderator: Dick Flanagan K7VC: icom-owner at mailman.qth.net
> Icom Users Net: Sundays, 1700Z, 14.316 MHz
> Icom FAQ: http://www.qsl.net/icom/
> To support QSL/QTH.net: http://www.qsl.net/donate.html
>
>