[ICOM] HM-36 mic

[Edward Dickinson, III]

Don - 

See if this works...

	Remove screw
	Insert plug into jack
	Screw plug ring onto jack
	Install screw


Regards,
Dick - KA5KKT 

-----Original Message-----
From: icom-bounces at mailman.qth.net [mailto:icom-bounces at mailman.qth.net] On
Behalf Of w0dg at everestkc.net
Sent: Sunday, February 14, 2010 8:57 PM
To: icom at mailman.qth.net
Subject: [ICOM] HM-36 mic

Hi Group,

Have the above mic.  The outter ring will not screw on to receiver due to
screw below the ring extending slightly. Cannot crack the code on moving
this lock ring.  Any help appreciated, I hope this makes sense. 

73,  Don    w0dg
----
Your Moderator: Dick Flanagan K7VC: icom-owner at mailman.qth.net Icom Users
Net: Sundays, 1700Z, 14.316 MHz Icom FAQ: http://www.qsl.net/icom/ To
support QSL/QTH.net: http://www.qsl.net/donate.html