[ICOM] Icom 765 Low output on 80 and 160 meters receive on these

[Gary P. Fiber]

On 4/21/2010 12:34 PM, Jeff wrote:
>   Adam VA7OJ/AB4OJ wrote:
> There may be a defective component in the BPF group on the RF board. You can
> check the RF power output at J8 (RF Unit) with an RF millivoltmeter. The
> signal level at J8 should be approx. +20 dBm on all bands.
>
>
>    Since I don't have an RF voltmeter could I use an o-scope to with a X10
> probe to check this signal at J8. The scope has a 275mhz bandwidth and has a
> switch for 50 ohm 5vrms max also Sorry about all the questions but it is the
> only way I can learn.
>
>
> Best Regards Jeff kd4lyh
>    
In case you forgot or don't have a dBm to voltage converter handy, this 
is a nice one.
http://www.minicircuits.com/pages/pdfs/dg03-110.pdf

Gary K8IZ
-- 

Gary P. Fiber K8IZ
Electronic Communications Systems Technician - Field
Electronic surveillance technician
General Radio Telephone Operators License PG-19-6691,
  with Shipboard Radar Endorsement.
Washington State Resident.