[ICOM] Icom 765 Low output on 80 and 160 meters receive on these

[Jeff]

 Adam VA7OJ/AB4OJ wrote:
There may be a defective component in the BPF group on the RF board. You can
check the RF power output at J8 (RF Unit) with an RF millivoltmeter. The
signal level at J8 should be approx. +20 dBm on all bands.


  Since I don't have an RF voltmeter could I use an o-scope to with a X10
probe to check this signal at J8. The scope has a 275mhz bandwidth and has a
switch for 50 ohm 5vrms max also Sorry about all the questions but it is the
only way I can learn.


Best Regards Jeff kd4lyh
No virus found in this outgoing message.
Checked by AVG - www.avg.com 
Version: 9.0.814 / Virus Database: 271.1.1/2826 - Release Date: 04/21/10
07:09:00