[ICOM] Alignment Tools

[Larry L. Hinton]

Mel,

I didn't see any hex tip tools for the coils on the vesseltools site. Was
there a kit that had them?

Larry
K7YBZ

-----Original Message-----
From: icom-bounces at mailman.qth.net [mailto:icom-bounces at mailman.qth.net] On
Behalf Of Mel
Sent: Thursday, November 26, 2009 6:40 AM
To: gswynar at durham.net; icom at mailman.qth.net
Subject: Re: [ICOM] Alignment Tools

I use ceramic tools made by Vessel.
I've had mine for about 15 years.
http://www.vesseltools.com/handceramic.html
----
Your Moderator: Dick Flanagan K7VC: icom-owner at mailman.qth.net
Icom Users Net: Sundays, 1700Z, 14.316 MHz
Icom FAQ: http://www.qsl.net/icom/
To support QSL/QTH.net: http://www.qsl.net/donate.html