[ICOM] IC-21A

[Gary Fiber]

Rich,

If you have the schematic for the DV-21 it should not be to hard to 
figure out the AC input.
I am not sure if Scott Malcom ever worked on one of those but seem to 
remember Kuni Okuma working on one while he and I were at Icom America.
Kuni owns :
Comtek
26611 Hwy 3 NW
Poulsbo, WA  98370
Phone: (360) 779-9730

You might give him a call. I am sure he runs normal business hours 8 
to 5 or something like that.

Gary K8IZ


At 08:43 PM 1/14/2009, you wrote:
>Recently I procured a very nice IC-21A for about $50. Cosmetic condx 
>is above average for this radio some 30 years after it was produced. 
>However, someone took the handle and the tilt-bail off of the radio 
>set. Anybody out there have a IC-21 tilt-bail they would like to 
>find a home for??
>
>I also have the matching digi-VFO. It needs a power cord (which I 
>can fabricate using a molex plug from Radio Shack and an old 120V AC 
>line cord...just need to know which pins to put the 120V on so I 
>don't smoke the thing. Also, the keypad is sticky. Does anyone have 
>any experience taking apart these keypads and cleaning them up?
>
>Thanks
>
>73
>
>Rich K7SZ
>----
>Your Moderator: Dick Flanagan K7VC: icom-owner at mailman.qth.net
>Icom Users Net: Sundays, 1700Z, 14.316 MHz
>Icom FAQ: http://www.qsl.net/icom/

Gary Fiber K8IZ
GROL PG-19-6691
Washington State Resident