[ICOM] PW1 AMP/Protect Light

[Dave Meitzen]

Confirm antenna low SWR

Turn the exciter drive to zero and see if the fault light comes on.

If not start turning it up looking at the amps PO. Could still be the
antenna. If you have two antennas then swap to eliminate.

Make sure the ALC connector is clean and attached.

Let me know what happens
Dave

-----Original Message-----
From: icom-bounces at mailman.qth.net [mailto:icom-bounces at mailman.qth.net] On
Behalf Of The Romagni's
Sent: Saturday, December 19, 2009 10:31 AM
To: icom at mailman.qth.net
Subject: [ICOM] PW1 AMP/Protect Light

Good morning,

Today out of the blue (this unit has been working fine), when ever I turned
the amp on, and key the rig, the PW1 amp/protect light goes on
automatically. any suggestions, I tried a hard reset but still nada.

I sort of starting to think this might need a trip to the shop.

73

Steve
W4DTA
----
Your Moderator: Dick Flanagan K7VC: icom-owner at mailman.qth.net
Icom Users Net: Sundays, 1700Z, 14.316 MHz
Icom FAQ: http://www.qsl.net/icom/
To support QSL/QTH.net: http://www.qsl.net/donate.html