[ICOM] IC-207 problems

[Randy Allen]

Sounds like it's set for DTMF Programming.

 From Page 46 of the manual:

➀ Push [DTMF] for one sec. and “d” appears in place of the
	100 MHz digit as shown below.
➁ Push [SET] to enter the programming condition.
➂ Rotate the tuning dial to select the desired channel.
➃ Push [SET] or [MONI] to select the cursor.
➄ Rotate the dial to select a digit.
•“E” stands for “M” and “F” stands for “#.”
➅ Repeat steps ➃ and ➄ until the last digit is entered.
• The S/RF indicator shows the digit group. The indication in-
creases every 6 digits.
• Select “–” to clear the remaining digits when programming over a
previously used memory channel.
➆ Push [V/MHz] exit the programming condition.

Hope this helps

73

Randy

Larry Winslow wrote:
> I've got 2 problems with my IC-207.
> 
> 1) there is not receive audio;
> 2) the display has become strange. Instead of reading 146.960, it reads 
> d46.960.
> 
> Any suggestions?
> Thanks
> 73 - Larry WØNFU
> Lake Forest Park, WA
> larry_w at comcast.net
> 
> ----
> Your Moderator: Dick Flanagan K7VC: icom-owner at mailman.qth.net
> Icom Users Net: Sundays, 1700Z, 14.316 MHz
> Icom FAQ: http://www.qsl.net/icom/
> To support QSL/QTH.net: http://www.qsl.net/donate.html
> 


-- 
Randy Allen, KAØAZS