[ICOM] Using Microham Microkeyer II with IC7600

[John Gaynard]

Interface cable is the same cable - same pinout.  It's the rig in the setup
option that is missing.  I tried the IC7700 option in setup and it did not
seem to work - probably wrong CI-V address.

John K8WDN

-----Original Message-----
From: icom-bounces at mailman.qth.net [mailto:icom-bounces at mailman.qth.net] On
Behalf Of Gary P. Fiber
Sent: Thursday, December 03, 2009 1:56 PM
To: ICOM Reflector
Subject: Re: [ICOM] Using Microham Microkeyer II with IC7600

Just looking at the web page for this device I'd bet it will work fine 
providing the IC-7600 has the proper inputs. I'd also suspect the 7600 
and 7700 support much of the same pin out BUT I have not looked at 
either manual for those products. You may have to roll your own 
interface cable.

Gary K8IZ



John Gaynard wrote:
> Does anyone use the Microham Microkeyer II with the IC7600.  The IC7700
> appears in the rig list but not the IC7600.  The interface cable is the
same
> as the IC756ProIII
>
>  
>
> John
>
> John Gaynard K8WDN
>
> ----
> Your Moderator: Dick Flanagan K7VC: icom-owner at mailman.qth.net
> Icom Users Net: Sundays, 1700Z, 14.316 MHz
> Icom FAQ: http://www.qsl.net/icom/
> To support QSL/QTH.net: http://www.qsl.net/donate.html
>
>   

----
Your Moderator: Dick Flanagan K7VC: icom-owner at mailman.qth.net
Icom Users Net: Sundays, 1700Z, 14.316 MHz
Icom FAQ: http://www.qsl.net/icom/
To support QSL/QTH.net: http://www.qsl.net/donate.html