[ICOM] IC7000 Mike

[Charles.Frost at aliefisd.net]

Well I have done everything except replace the mike cord which I am
going to do this weekend. 
Frosty
K5LBU

CTE
OLLE MS K5OMS 
	
-----Original Message-----
From: icom-bounces at mailman.qth.net [mailto:icom-bounces at mailman.qth.net]
On Behalf Of Julio Peralta
Sent: Wednesday, August 19, 2009 10:49 AM
To: 'ICOM Reflector'
Subject: Re: [ICOM] IC7000 Mike

I have had an issue with a couple of Icom mikes each time I traced the
problem to broken solder connections on the pc board where the ptt
switch is
soldered. All I had to do was re-heat the solder pads and all was good
again. I hope this will work for you.

Julio, W4HY

-----Original Message-----
From: icom-bounces at mailman.qth.net [mailto:icom-bounces at mailman.qth.net]
On
Behalf Of Charles.Frost at aliefisd.net
Sent: Wednesday, August 19, 2009 10:14 AM
To: icom at mailman.qth.net
Subject: [ICOM] IC7000 Mike

I have a IC7000 that the mike push to talk on the hand mike has stoped
working anyone else have the same problem??

 

Frosty

K5LBU

 


OLLE MS K5OMS 

 

----
Your Moderator: Dick Flanagan K7VC: icom-owner at mailman.qth.net
Icom Users Net: Sundays, 1700Z, 14.316 MHz
Icom FAQ: http://www.qsl.net/icom/
To support QSL/QTH.net: http://www.qsl.net/donate.html


----
Your Moderator: Dick Flanagan K7VC: icom-owner at mailman.qth.net
Icom Users Net: Sundays, 1700Z, 14.316 MHz
Icom FAQ: http://www.qsl.net/icom/
To support QSL/QTH.net: http://www.qsl.net/donate.html