[ICOM] VOX T/R switching from ACC input

[Adam Farson]

Hi Dave,

In general, on all Icom transceivers ACC1 Pin 4 (baseband input) bypasses
the VOX circuit. You will need to send a T/R CI-V command from the computer
(typically 1C 00 00 = RX, 1C 00 01 = TX. Check the CI-V manual.) 

Cheers for now, 73,
Adam VA7OJ/AB4OJ


-----Original Message-----
From: icom-bounces at mailman.qth.net [mailto:icom-bounces at mailman.qth.net] On
Behalf Of Dave Edwards
Sent: 30-Nov-08 15:31
To: icom at mailman.qth.net
Subject: [ICOM] VOX T/R switching from ACC input

Can anyone save me some diggin on this one?  I was hoping to set up my
IC-736 on PSK to use VOX to go into transmit mode. Using the computer, if I
hit the transmit button, I hear my tones (on another receiver) but the rig
will not go into transmit using VOX. Am I to assume the pin 4 input on the
ACC socket does not go through the VOX circuitry??
Thanks for any tips!
...Dave
----
Your Moderator: Dick Flanagan K7VC: icom-owner at mailman.qth.net Icom Users
Net: Sundays, 1700Z, 14.316 MHz Icom FAQ: http://www.qsl.net/icom/