[ICOM] 735 Filter Instal

[Nathan Moreschi]

That makes sense then - maybe I'll pull the main board out and solder the 
filter to it...

Thanks!

Nate
----- Original Message ----- 
From: "Gary Fiber" <gfiber at comcast.net>
To: "ICOM Reflector" <icom at mailman.qth.net>
Sent: Saturday, November 10, 2007 9:30 PM
Subject: Re: [ICOM] 735 Filter Instal


> Nate
>
> The filter soldered into the main board on the 735. It was not just a plug 
> in type.
>
> Gary K8IZ
>
> At 12:03 PM 11/10/2007, you wrote:
>>I'm trying to install a 400hz inrad filter in my 735, but I'm having an 
>>issue getting the pins to make a good connection. The filter isn't 
>>designed to physically fit in the intendend spot in the 735, so a few 
>>leads are needed to connect the filter to the filter plugs. The pins are 
>>just a bit to small to fit in snug.
>>
>>Any suggestions out there?
>>73,
>>
>>Nate/N4YDU
>>----
>>Your Moderator: Dick Flanagan K7VC: icom-owner at mailman.qth.net
>>Icom Users Net: Sundays, 1700Z, 14.316 MHz
>>Icom FAQ: http://www.qsl.net/icom/
>>
>>
>>--
>>No virus found in this incoming message.
>>Checked by AVG Free Edition.
>>Version: 7.5.503 / Virus Database: 269.15.27/1121 - Release Date: 
>>11/9/2007 7:29 PM
>
> Gary Fiber K8IZ
> GROL PG-19-6691
> Washington State Resident
>
>
> ----
> Your Moderator: Dick Flanagan K7VC: icom-owner at mailman.qth.net
> Icom Users Net: Sundays, 1700Z, 14.316 MHz
> Icom FAQ: http://www.qsl.net/icom/